Replacement 3/32" x 1" Roll Pin for Lippert Stabilizer Jacks

See what our Experts say about this Lippert Accessories and Parts

• Replacement Pins for Lippert Electric Stabilizer Jack
  I believe you are referring to the roll pins for your Lippert Electric Stabilizer Jack. If this is the case then we do have the replacements available with part # LC125462 for the 5/32" Roll Pin and part # LC181003 for the 3/32" Roll Pin. I'm not quite sure what you are referring to when you mentioned a coupler. If you are able to email me a picture of this particular part I will be happy to see if it is available.
  view full answer...
• Recommended Way To Replace Shear Pin On Lippert Components Power Stabilizer Jack
  Per the manufacturer when it comes to the shear pins being broken you would have to replace the whole Lippert Jack # LC298707 because the shear pins are not replaceable, and there is no way to fix them. What you will need to do is purchase a whole new # LC298707. I attached a review video link below.
  view full answer...
• Lippert Rear Stabilizer Model 201353 Shear Pin Replacement
  I contacted Lippert Components to ensure we get you the right pin and they said that there are two pins located right by each other there at the motor. These should both be replaced. The larger one Replacement 5/32" x 1" Roll Pin for Lippert Components Stabilizer Jacks part # LC125462 is the one slightly closer to the motor and the smaller Replacement 3/32" x 1" Roll Pin for Lippert Components Stabilizer Jacks part # LC181003 is located about an inch closer to the middle of the camper....
  view full answer...
• Replacement Pin Options For Sheared pin On Lippert PSx2 Stabilizer Jack Assembly 695602
  I reached out to Lippert for help identifying the pin that you have missing but unfortunately they do not list this as a replacement part for your PSx2 Stabilizer jack. We do carry a 5/32" # LC125462 and 3/32" # LC181003 roll pin which was used on other stabilizers and may work on your jack. If you can measure the hole opening this will help to determine if one of these will fit your jack. Both pins are 1" long so be sure to verify length as well as diameter needed. If you have a different...
  view full answer...
  
• Replacement Roll Pins for Lippert 201445 Stabilizer Jack
  The replacement parts for the retaining pin that you are talking about for your Lippert 201445 Stabilizer Jack can be found on our site listed as parts # LC181003 and # LC125462. Part LC181003 is the 3/32 roll pin that you are needing and part 125462 is the 5/32 roll pin that you will be needing.
  view full answer...
  

Do you have a question about this Accessories and Part?