Kodiak 12" Rotor - 6 on 5-1/2 - Stainless Steel - 5,200 lbs to 6,000 lbs

Video Transcript for Review of Kodiak Trailer Brake Parts - Replacement 12 Inch Rotor - KR12S

Ellen: Hey everybody. I'm Ellen here at etrailer.com and we're going to be taking a quick look at the Kodiak 12 Inch Rotor. If you need a replacement for a rotor that's gotten worn out or damaged, this is going to be a great fit for you. I'll go over the measurements with you in just a minute to make sure it's the right fit for your particular application.It's a good idea to get a rotor for either side of your trailer so that you're replacing both at the same time. That way they can wear the same amount and you're not going to get a better or worse performance from one side versus the other. So it's a good idea to at least get these in pairs, if not to do the whole trailer at once.

So just something to keep in mind there. If one's bad, probably other ones are bad too. So check that out.As far as what this actually fits, you can see that it is a slip on over the hub rotor. Makes it pretty easy if you're converting an idler axle to a disc brake axle. It is a heavy-duty stainless steel construction so we don't have to worry about any rust or corrosion.

It's great for any kind of marine use. This can be in the water and you don't have to worry about any rust building up.The design is to allow heat to escape so we'll have this vented design here and that just helps to dissipate out the heat, so it doesn't get any kind of heat-related damage. It does have a 1000-hour salt spray rating. Again, going back to it being great for a marine application, even if you're going in seawater or saltwater. As far as the axle that this will fit, it can work with an axle capacity of 5200 pounds up to a 6,000 pound axle and works with wheel sizes 15 inch and larger.The bolt pattern here is six, you can see, will have six holes and they're separated by five and a half inches going from center of one hole to the center of the one directly opposite.

As far as the size for the diameter, the outer diameter so from here to here is about 12 and an eighth inch. The inner diameter is about seven and 11 sixteenths. The bolt hole diameters are a half inch.And that's pretty much all there is to it for our look at the Kodiak 12 Inch Rotor with 6 on 5-1/2 bolt pattern. I hope this has been helpful deciding if this is going to be the right part for you. We do have a lot of accessories and parts here at etrailer.com for any kind of trailer needs.

So check them out. Thanks for watching.