Rubber Truck Seal for Tonneau Covers - Stick On - 25' Long x 1-1/2" Wide x 1/2" Tall

Video Transcript for Review of etrailer Stick On Rubber Truck Seal Tonneau Covers 25 Foot - CS57VR

Hi everybody, Andy here with etrailer.com and today we're gonna take a look at this etrailer Stick On Rubber Truck Seal for Tonneau Covers. With this stick on rubber seal you're going to be able to replace your old and worn out seal around your Tonneau Cover before water damage could create a costly headache for you. Now, this is a peel and stick installation with pre-applied 3M adhesive backing. Now, surface preparation is recommended to remove any old adhesive, and then you're just going to simply remove the backing and apply the seal to the frame. And then, you would just use scissors to trim any extra seal and this will set in about 48 hours. Now, this is made here in the USA of EPDM rubber.

This is not going to shrink, crack or fade over time and it's also resistant to UV damage. Now, let me go ahead and just give you some overall measurements here. Get my ruler here, looking at the overall width of this seal. As you can see, we're sitting right at one and a half inches. And then, looking at what's going to be the height of this seal when you have this installed, we're looking at right about half an inch.

Now, on my table I do have the 15 foot version, but we do also offer this in 25 and 50 feet versions as well. So, on your screen, I am including the item numbers for those respective lengths. So, whichever length you are looking for, whether it's the 15, the 25, or the 50 foot version, just take the item number and put it in the search field of our website and it will take you to that length that you are looking for. Application instructions are included to walk you through the very easy steps to install this with the 3M adhesive backing. And that's going to conclude our look today.

I do hope that it was helpful for you. Again, my name is Andy. Thank you for joining me.