Replacement Drop Leg for Bulldog Square Trailer Jacks - 18" - 8,000 lbs

Video Transcript for Bulldog Square Leg Kit with Pin Review

Hello neighbors. It's Brad here at etrailer. And today we're taking a look at the Bulldog Square drop-leg for your trailer or camper jack. This is gonna fit a 2 inch by 2 inch square jack and overall it's 18 inches tall. And you'll see you have the 5 adjustment holes here that are spaced 3 inches apart from each other. You know, if you gonna have your foot pad here, which is gonna be 6 inches by 8 inches, so that's gonna make great contact with the ground keeping it stable.

When you're ready to use it simply place this into your jack, figure out your adjustment, whatever you like as far as height on the adjustment holes. And then also included is this nice pin, which is gonna be be great, because you have this chain here. That's gonna allow you to snap this in place. And now, that's not coming out. The beauty of it is you're not having to crank all the time to get that clearance or for it to make contact.

You can simply take your pin, pull that out, drop it to that height, and that's gonna get you pretty close to where you need to be. So that's gonna take that cranking time down to a minimum, and save your arm strength a little bit. Now with just a few rotations, this is gonna allow us to raise up our trailer, and get our jack out of place. So this is gonna work on trailers and campers with a square jack and it's rated for 8,000 pounds. So it should work quite well for your needs, assuming you're not going over that weight limit.

And that was a look at the Bulldog Square drop-leg for your jack on camper or your trailer..