Pro Series Detachable Caster with Pin Review Video

I do have an option for you to replace the bottom plate of your trailer jack with a wheel assembly. The option I have is the Pro Series 6", Detachable Caster w/ Pin for 2" Diameter Jacks - 1,200 lbs #PS1400750340. This corrosion-resistant,…

The most common outer diameter for an a-frame trailer jack is 2-1/4 inch but the 2 inch diameter you have is also reasonably common as well. In nearly all situations a 2-1/4 inch jack will replace a 2 inch jack as the hole on the trailer frame where…

The vast majority of trailer jack wheels don't use traditional steel ball bearings as they aren't really meant for rotation speed but rather weight bearings. I am not aware of any options which use traditional steel ball bearings. The…

Yes, the Replacement Caster Wheel #UF49-954035 that you referenced is compatible with trailer jack inner tubes that measure 1-3/4" in diameter. This is verified in the attached review video.

If you were on level, smooth ground and you had this Pro Series Detachable Caster #PS1400750340 installed on your jack you should be able to move your trailer around. This of course depends on your physical strength as well, but you should not have a…

Yes, the Pro Series 6" Detachable Caster #PS1400750340 does swivel. If you check out the video I've linked for you, it will display this at about the 0:20 mark. This caster is designed to fit jacks with 2" tubing and has a 1,200 lbs…

There are no bearings in the Pro Series 6", Detachable Caster #PS1400750340 that you referenced. It's basically just a bushing like you mentioned.

Wheel casters like the part #PS1400750340 that you referenced are designed for exactly what you mentioned. They allow you to move the coupler of a trailer a couple inches over to fit on a coupler ball. These aren't universal fit wheels though and…

The 'sleeve' or shank portion of the Fulton #F500266 caster assembly is meant to be compatible with Fulton F2 trailer jacks, which is why it's kind of oddly shaped. At the widest point, that sleeve is 2-1/2 inches in diameter, as shown in…

Because the fit to the trailer of a pipe mount jack is a little loose due to the large tolerance between the jack and the pipe mount on the trailer, it's pretty rare to find a pipe mount jack with a removable foot that would allow a caster wheel…

We have just what you are looking for with the trailer hub part #AKIHUB-545-35-G-EZ-K. This has the correct bearing to fit your spindle and has the 5 on 4-1/2 inch bolt pattern you are looking for as well.

You need to do a little more checking to be sure but I think we have what you need. Check your bearing numbers. If you have #L68149 for your inner and #L44649 for your outer then switching to a 5 on 4-1/2 bolt pattern is no problem at all. If your…