Is There a Trailer Jack Wheel That Uses Ball Bearings

Question

Question:

Do you have a jack swivel caster wheel with a 2 receiver that has ball bearings? Other types just dons turn with washers as pivot points. Thanks

asked by: Mark L

0

Expert Reply:

The vast majority of trailer jack wheels don't use traditional steel ball bearings as they aren't really meant for rotation speed but rather weight bearings. I am not aware of any options which use traditional steel ball bearings. The Replacement Caster Wheel for Ultra-Fab Manual 2" Trailer Jack part # UF49-954035 uses nylon bushings which provide a smoother than normal rotation.

expert reply by: Conner L

0

Answer 1

Since the wheel on your jack is removable you can definitely replace it! Just let me know what the diameter of the inner tube of your jack is along with the pin hole diameter and I can make a recommendation. For example, the removable wheel…

view full answer...

Answer 2

We have just what you're looking for with the Gen-Y Anti-Rattle Clamp for 2" Hitch Receivers #GY88XR. The sleeve acts as a wedge to take out play between your hitch receiver and extender. Although it does not not require a wrench and a…

view full answer...

Answer 3

Yes, you can install a fifth wheel hitch on a 2021 GMC Sierra 2500 with Carbon Pro Bed. For this, I recommend the Demco Hijacker Autoslide 5th Wheel Trailer Hitch part #DM8550034 with Demco Hijacker Premier Series Above-Bed Base Rails and Custom…

view full answer...

Answer 4

7k Dexter axles are a little annoying as they can have two different seals with only difference being the inner diameter. If the seal has an inner diameter of 2.250 inch you'd want the part #GS-2250DL or if instead you had the spindle diameter as…

view full answer...

Answer 5

The auxiliary 12-volt wire that runs from the 7-way connection to 7-way trailer plug will supply 12-volt power from the vehicle to the trailer. The 12 -volt power will allow interior or exterior lights to run that are not wired in to the…

view full answer...

Answer 6

When towing with the Curt Echo Mobile Trailer Brake Controller #C51180 installed I do recommend having the app/software opened up on your phone during travel, however it is not required for proper operation. The ideal setup would be to have the phone…

view full answer...

Answer 7

There are a few variables that go into determining the proper torque setting for the lugs nuts once you install your wheel over the Kodiak Disc Brake Kit #K2R35S and it can range from 75 ft-lbs up to 120 ft-lbs depending on your wheel size and the…

view full answer...

Answer 8

It sounds like you are looking for a caster wheel for a trailer jack. If that is the case then we do have some options like the Ram Removable Assembly part #JC-101 for a 2" outer tube and 1-3/4" inner tube.

view full answer...

Answer 9

Boat jacks, including the Fulton jack you have, are typically constructed so that the inner tube of the jack and the yoke and caster are all one piece. Because of the way its constructed, the caster won't easily turn until the boat is rolling.…

view full answer...

Answer 10

Having 2 wheels will provide more surface area/contact with the ground. This could actually make it more difficult to maneuver compared to a single wheel. But two wheels are better than one when not on pavement. A single wheel tends to dig into dirt…

view full answer...

Answer 11

Due to the unique configuration of the Fulton Wheel Assembly #F500266, it would not be compatible with a square 2" jack; I am not aware of a caster wheel assembly that will fit a square 2" jack tube, mostly because those jacks have higher…

view full answer...

Is There a Trailer Jack Wheel That Uses Ball Bearings

Product Page this Question was Asked From

Continue Researching