Demco A-Frame Trailer Coupler - Standard Coupler - DM14793-81 Review Video

The only differences between the Demco eZ-Latch Couplers #DM37ZR and #DM14793-81 is that the former has integrated loop holes for installing safety chains and a about a 2" drop while the latter doesn't come with provisions for attaching the…

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

There is! To replace the standard pin and clip on the Curt QuickPin No Latch A-Frame Trailer Coupler #C84DR Curt actually recommend the Hitch Lock #C23025 which is what I recommend going with!

If you look at the diagram that I received from my contact at Demco, you can see several of the dimensions of the #DM14793-81 trailer coupler. If there were other dimensions you were needing, please let me know.

Yes, you can remove your weld-on coupler and install a new bolt-on coupler that fits a 2 inch ball. There is just a few things you need to do to before and when installing. You need to know what channel size and the weight capacity you will need for…

Most A-Frame Trailer Couplers have a standard of 50 degrees. I produced a short video for you showing the angle of the etrailer A-Frame Coupler, part #CA5400. I have also linked an FAQ on trailer couplers.

Yes, it will! The Curt Pintle Hook with 2-5/16" Ball item #C45908 will easily connect to your portable silo's lunette ring and allow you to safely tow it. This ball mount fits a 2-1/2" hitch receiver, includes a 2-5/16" hitch ball,…

Thanks so much for the photos, and there isn't a replacement for just the front coupler portion of the long-discontinued coupler you have. So in order to switch out from a 2" to a 2-5/16" coupler attachment, you will need to replace the…

Yes, you can replace your weld-on coupler with a bolt-on. You'll just need to drill the holes. Then, if you wanted to go back to a weld-on later that would be fine too. Just to confirm you can check with the trailer's manufacturer that…

Yes, the Blue Ox Adjustable Ball Mount with Pintle Hook #BLU45XR can be positioned in either a drop or rise position. I have included an image showing it in a rise position like you are needing.

I went out to the warehouse to measure the Demco A-Frame Trailer Coupler #DM14793-81 that you asked about and found that it measures 3-1/2" from the bottom to the top. I have attached a picture to demonstrate. If your safety chains are welded to…

From the rear of the coupler portion on the Demco A-Frame Coupler #DM14793-81 to the center of the center bolt hole there is a distance of 4-1/2 inches. From the rear of the A-Frame mount to the center of the center hole there is a distance of 4-3/4…