Optronics Identification Light Bar Installation Video

I attached a picture that shows what type of lighting requirements are needed for a trailer over 80 inches in width as well as a link down below that covers this as well.

The matching driver side light to go with the part #STL16RB that you have is the part #STL17RB that you also mentioned. The reason this light says it has an additional function is that the bottom of it has a clear lens to illuminate a license plate.

The Nylon Bushing #TRBU11561 that you referenced will work great for you. It will give you a single bushing that will match what you have well as it has an inner diameter of 9/16 inch and an outer diameter of 1 inch.

The part #277-000114 that you referenced can only turn on both lights or turn off both lights. They can not be activated independently. You may instead be interested in the LED Dome Light part #277-000340.

The Optronics LED RV Exterior Scene Light - Submersible part #UCL41CB is a surface mount light that installs using the two mounting holes in the flanges on either side of the light. The distance between the mounting holes is 7.87" and the…

The correct torque for installing lug nuts on your 5 X 8 trailer's 5-lug wheels will depend on the size of the lugs. For a 1/2-inch lug the torque spec ranges from 75- to 85-ft-lbs. For a 9/16-inch lug the torque spec ranges from 135- to…

I have attached a chart you can check out that describes the torque needed per wheel size, wheel stud size and material. For an 8-inch wheel with a 1/2-inch wheel stud the torque is 75 to 86 ft-lbs. For a 15 inch steel wheel with 1/2 inch wheel…

The lights will need to be replaced, we have some great options for this. The Optronics LED Combination Trailer Tail Lights part #TLL160RK looks to be a great match for your existing taillights and the Custer Trailer LED Clearance Identification…

The correct torque range for the Kenda Karrier ST175/80R13 Radial Trailer Tire with 13" Black Mod Wheel - 5 on 4-1/2 - LR D part #AM31990 is 75-85 ft. lbs. If you need a torque wrench for this I recommend the Powerbuilt Beam-Type Torque Wrench…

The bolt pattern of the Electric Trailer Brake Assembly #AKEBRK-35L that you referenced is 4 on 4 inch. If you check out the picture I attached you will see all the dimensions of the flange. You might try measuring yours again to be certain as it…

Yes, the CE Smith Padlock Brackets #CE26002Z-2 do have the 1/2-20 thread size.

We do have everything you need to re-wire your 6 X 12 enclosed trailer. We also have any of the lights you said you want to use as well. For trailer wiring I recommend installing a 7-way so you can operate the light inside the trailer. The 7-way…