Review of Optronics Trailer Lights - Tail Lights - STL79RB Video

Thanks for the axle information, Mike! Here are the correct parts according to my contact at Curt: - Bearing #02475 and Race #02420 - Bearing #25580 and Race #25520 - Grease Seals #RG06-070

There are differences in them but we do have what you are looking for and they can in some situations be used together. The Replacement Trailer Hub Bearing you have part #02475 and Replacement Race for 02475 Bearing part #02420 are designed to work…

Some 5-Pole flat connectors use a total of 6 wires. They operate as follows: Blue - trailer brakes Green - right hand brake and turn signals Yellow - left hand brake and turn signals Brown/Green - right hand running lights Brown/Yellow - left hand…

Did you have a 4-pin connector that had 5 wires or was it a 5-pin connector? There is a big difference since you normally see a 5-pin connector on a boat trailer with the 5th pin used for an electric reverse lockout solenoid on a brake actuating…

The Lippert 2420801 hub is an 8k hub with an 8 lug bolt pattern so for a replacement you'd just need the part #8-285-10UC3-A.

We have grease caps for a 7,000 lb Lippert axle (including torsion axles), though I do need to say that grease caps are are drive-in, and oil caps are screw-in. I verified with Lippert what the correct grease cap is for their 7,000 lb axle, which…

EZ Lube Dust Caps, like #DC200L-DCRP, have a rubber plug that can be removed to access the zerk fitting. The rubber plug can be removed by gently prying it up with a flathead screwdriver. If your dust cap is in good condition and you want to avoid…

Yes, I had the TremPro 645 Silicone All Purpose Sealant for RVs and Trailers - Clear - 10.1oz Cartridge - Qty 1 #FAS59FR added to the site for you.

I'd recommend going with the #EM34423 instead as it's closer to the length you need as it is 5-1/2 feet long and it has a higher capacity at 1,333 lbs working load limit and 4,000 lbs break strength. The ratchet portion could easily…

The SAE STIAP2 04 DOT number you provided is a DOT approval number, which states that the lens is compliant with DOT regulations. Because of that, that number isn't typically a good identifier for finding a replacement lens. However, in…

If your trailer brakes activate when using the manual override but not when pushing on the brake pedal you may have a bad connection or a faulty brake switch. I have also linked below our article on Brake Controller Troubleshooting. Also if you…

This is a really good question, but the short answer is that the Ford OEM brake controller of your 2019 Ford F-350 is compatible with the Hydrastar actuators like #HBA16. The chart you found where it says only up to 2017 hasn't been updated…