CargoBuckle G3 Retractable Ratchet Straps with S-Hooks Review Video

Dexter Nev-R-Lube hubs such as the part #8-388-80UC3 are designed to fit Dexter Nev-R-Lube Axles. These hubs use a special cartridge style bearing that is only compatible with the spindles on a Nev-R-Lube Axle. With this in mind you would not be able…

I am surprised you have a #10-40 hub seal. The Trailer Hub and Drum Assembly #8-247-50UC3 that you said you have would take a part #58846 seal or #RG06-020. And then for bearing part #L68149 for the inner bearing, part #L44649 as outer bearing. For…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

The Hooks on The Erickson Ratchet Straps #EM34416 are 2" wide on the outside. The inner diameter of the hook is right about 1-1/4".

Based on your dimensions you have a BT8 style hub so the part #AKIHUB-440-2-1K you mentioned would fit and work well. The length of your spindle matches what this is compatible with as well.

The Kenda K353 Bias Trailer Tire - 5.70-8 #AM10013 is 18" tall. The section width is 5.8" also.

The difference between load ranges varies based on the tire size and brand. When comparing two tires of the same size and brand, a load range D tire will always have a greater weight capacity and psi rating than a load range C. However, when…

We have a replacement tire that would work great to replace your current 4.80-12 wheel and tire, but nothing we offer in that size is rated for exceeding 65 miles per hour. The part #AM10060 would work great as it is a 4.80-12 tire. This tire has a…

Since most trailer manufacturers do not make wheel and tire information available to the general public, it is hard for me to tell you what size lug nuts you have on the wheel. I can tell you they do have caps over them. The most common size of lug…

Electric brakes have 2 wires located at the back. One is for power and the other is for ground (it doesn't matter which is used for which function). The ground wires should be connected to the trailer frame. The only other place that would carry…

I attached an install video and installation instructions for the install harness part #3016 that is recommended for installing the Prodigy P3 Brake Controller part #90195 that you referenced.