Curt Hitch Product Line Manufacturer Demo Video

I went to our warehouse and measured Curt Hitch #14055 to get you the mounting hole dimension you requested. The mounting hole spacing on the two flanges is 38-1/4-inches. The overall edge-to-edge spread at the two flanges is 40-inches.

The Curt Class IV Trailer Hitch Receiver #14055 is designed to fit all models of the Ford Van from 2000 to 2003 and the E-150, E-250, and E-350 vans from 2004 to 2014.

I have a solution for you, but the Curt #C15325 is a custom fit hitch designed for older Chevy K-Series pickups; the distance between the mounting holes from side to side will be approximately 35". We have seen many folks these days adding…

I spoke to my contact at Valterra and found that the #A10-5030FBK steps down a 50 amp service receptacle (2 X 120VAC) to 30 amps supply. This would work great for your camping trailers electrical system. I have linked the above mentioned product to…

In order to mount your OEM wiring connectors to the Curt Trailer Hitch Receiver #14211 on your 2004 Chevy Silverado 2500HD we have the No-Drill Bracket #C57202. This wraps around the crosstube of the trailer hitch and allows you to mount a connector…

To flat tow a vehicle, you'll need a hitch on the motor home, a towbar, a base plate kit installed on the tow vehicle, a tow bar wiring kit so that the taillights on the vehicle work along with those on the motor home, safety cables and a…

I did some checking and basically the cutout bumper is the regular factory bumper. The Curt hitch, #C15312, will fit up tighter and a little more recessed, apparently the same way the factory hitch does if it were installed. Some people like the…

The Curt Trailer Hitch Receiver - Custom Fit - Class IV, #C14357, can fit the 2004 Ford F-150 truck if that has never had a factory installed hitch. The factory hitch uses part of the bumper structure and if removed aftermarket hitches will not be…

I spoke with my contact at Reece and he confirmed that the Sidewinder Fifth Wheel King Pins with Rotating Turrets #RP34FR and #RP61412 both come with the Rotating Turret #RP61300. By adding Spacer Kit #RP61301 to #RP34FR you will not end up with the…

I went out to the warehouse and measured Curt trailer hitch #C13704 for you. The distance from the top of the mounting flanges to the top of the cross tube is 2 inches. I have included some pictures with additional measurements for you.

The Curt Class III trailer hitch #C13119 does have a 350-lb tongue weight (TW) rating as you noted, and that capacity must be enough for the weight of the bike rack itself plus that of your loaded bikes. A substantial 4-bike rack like the Hollywood…

In most cases, the tailgate on your truck can be left installed and in the down position while coupling to a 5th wheel trailer. Once the trailer is coupled you can then most likely raise the tailgate back up. I say in most cases as there could…