What is the Mounting Hole Spacing on Curt Class IV Hitch # 14055
Question:
What are is the center - to - center bolt hole measurements on this hitch?
asked by: Sam P
0
Expert Reply:
I went to our warehouse and measured Curt Hitch # 14055 to get you the mounting hole dimension you requested. The mounting hole spacing on the two flanges is 38-1/4-inches. The overall edge-to-edge spread at the two flanges is 40-inches.
expert reply by:
Adam R
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class IV - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class IV
- 1000 lbs TW
- 10000 lbs GTW
- 12000 lbs WD GTW
- 2 Inch Hitch
- 1200 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Installing 7-Way Trailer Connector on 2005 Ford E-150 Van
- Q&A: Recommended Trailer Hitch for Ford E-450 RV with High Towing Capacity
- Article: Trailer Wiring Diagrams
- Q&A: Tow Bar Lighting Solution for 2023 Jeep Wrangler that Allows Charge for Battery
- Article: Brake Controller Installation on a Ford Full-Size Van
- Q&A: Which Trailer Hitch Fits on a Ford E-350 Van
- Q&A: Where Do the Wires on the Universal Install Kit for Trailer Brake Controllers Get Installed?
- Q&A: Can 2007 Hyundai Santa Fe Without Trailer Tow Package Tow a Camper?
- Article: Rooftop Cargo Carriers
- Q&A: Which Hayes Brake Controller Install Harness Fits 2015 Ford E-450 Cutaway Chassis
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: Flat Towing Package for 2018 Jeep Wrangler JL and JL Unlimited