etrailer Trailer Hitch Receiver Installation - 2012 Toyota Tacoma Video

If your tow vehicle has a 3 wire system, this means the vehicle's turn, brake and tail light function are on separate wires. When installing the Vehicle Wiring Harness #C59496 referenced in your question, you will use the following…

The three wires of the Tekonsha Breakaway System part #50-85-313 will get wired as follows: The white wire attaches to the ground wire. The blue wire attaches to the brake output circuit that goes to the brake assemblies of the trailer. The black…

You likely can use any replacement switch since all they do is complete a circuit when the pin is pulled out. One wire on the switch should be connected to the positive battery terminal on the trailer. The other will tee into the wiring leading…

Starting with the trailer hitch, the Draw-Tite Max-Frame Trailer Hitch Receiver #75236 referenced in your question will indeed fit your 2011 Toyota Tacoma PreRunner and is the exact hitch I would recommend. This Class III trailer hitch will use…

The bumper does not need to be removed when installing the Curt Trailer Hitch Receiver - Custom Fit - Class III part #13323 on a 2009 Toyota Tacoma, but three of the bolts that hold the bumper in place will need to be loosened and two will need to…

The wheel included with wheel and tire combo #AM32395 has a zero offset. Most trailer wheels have a zero offset though there are a few exceptions. On our site if we do not state an offset then that means the wheel has a zero offset.

I attached two pictures to this page that have dimensions that you can use to determine if the Timbren Axle Less Kit part #A20RS545 will be able to fit and clear the deck. When this kit is installed on a trailer the wheel center will be 2-5/8 inches…

It's difficult to find the exact width of a rim without removing the tire from the rim, as you can see from the provided diagram. If you can tell me the size of the trailer tire, I would be happy to tell you what rim widths would be compatible.…

Draw-Tite front-mount hitch #65070 is a confirmed fit on your 2012 Toyota Tacoma 4WD. We have not had a chance to install this particular item nor the Curt equivalent #31313 on your same truck so for purposes of seeing the effect on your ground…

I have a much better solution for you than the Curt Hitch part #E-3S. You would want to go with a custom fit hitch instead like the part #13323 as it will bolt directly to the frame and provide you with a much stonger and easier to install hitch than…

You can use the Custom Locking Tailgate Handle, #PAL5500, with the back up camera on your 2010 Toyota Tacoma. The camera will insert in the slot on the back of the tailgate handle and a small plastic piece will need to be removed from the bottom of…

It sounds like your 2014 Toyota Tacoma did not come with a factory tow package. What can happen sometimes is that on models that did not come with the factory tow package not all of the wiring or contacts will be present. You would either need to by…