Where Do Each of the Wires of the Tekonsha Breakaway System part # 50-85-313 Run
Question:
I just purchased a Tekonsha breakaway kit with charger from you Code: 50-85-313 for my 10 year old S and H horse trailer which has a junction box. My problem is wiring the new battery which has three wires and the old one only had two - a black and a white. How should I splice the 3 new wires? I thank you in advance.
asked by: Gerald N
Expert Reply:
The three wires of the Tekonsha Breakaway System part # 50-85-313 will get wired as follows:
The white wire attaches to the ground wire.
The blue wire attaches to the brake output circuit that goes to the brake assemblies of the trailer.
The black wire runs to the 12 volt power source of the 7-way.
Product Page this Question was Asked From
Tekonsha Push-To-Test Trailer Breakaway Kit with Built-In Battery Charger - Top Load
- Trailer Breakaway Kit
- Kit with Charger
- Top Load
- Single-axle
- Tandem-axle
- Triple-axle
- LED Tester
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Tekonsha Push-To-Test Trailer Breakaway Kit with Built-In Battery Charger - Top Load
- Shop: Exterior LED Utility Light - Flush Mount - Powder Coated Aluminum - Clear Lens - 110V AC
- Shop: Curt Channel-Mount Coupler - 2-5/16" Ball - 12,000-lb Capacity
- Shop: Drop Leg for etrailer and Ram Jacks - 13-1/4" Tall - 5-1/4" Diameter Footplate - Zinc
- Shop: Trailer Wheel Center Cap, Chrome, 4.25" Pilot Size
- Shop: Trailer Hitch
- Shop: RV Exterior Lighting
- Shop: RV Rectangular Porch and Utility Light with Switch - Clear
- Shop: Gustafson 12V RV Porch Light - 8" Diameter - White
- Video: Excalibur Tires and Wheels 425EZ Review
- Shop: Trailer Wiring
- Shop: Brake Controller
- Q&A: Installation Instructions For Hopkins Engager Trailer BreakAway Kit
- Q&A: Trouble Removing Spindle Nut On Dexter 10K Axle
- Q&A: How To Install the Spindle Nut on a 12,000 Pound Dexter Axle
- Search Results: brake controller
- Video: etrailer.com Trailer Hitch Receiver Installation - 2013 Toyota Tacoma
- Video: etrailer Trailer Hitch Receiver Installation - 2012 Toyota Tacoma
- Article: Trailer Wiring Diagrams
- Q&A: Installation Instructions for Breakaway Kit Part # 50-85-313 and Trailer Wiring Junction Box # 38656
- Shop: RV Power Cord
- Shop: RV Electrical
- Search Results: ramp door spring
- Search Results: drop axle
- Q&A: How to Wire Break Away Switch on Hopkins Engager Break Away System
- Search Results: cam bar latch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Video: BulletProof Hitches Adjustable Ball Mount Pintle Lock Review
- Search Results: 23~113
- Search Results: 23~112
on Trailer Breakaway Kit
