Curt Trailer Brake Controller Wiring Adapter Installation - 2015 Toyota 4Runner Video

With the trailer tongue weight only accounting for 10-20% of the total trailer weight the Firestone Ride-Rite Air Helper Springs #F2407 are more than capable of leveling your 2014 Toyota Tacoma. With a loaded trailer weight of 4,000lbs this will give…

For your 2022 Toyota 4Runner with the factory tow package, the best brake controller is the Tow-Pro Elite from Redarc, and to mount it all you'll need is the correct wiring adapter: - Redarc Tow-Pro Elite Trailer Brake Controller #RED44FR -…

100/96 is the "load rating" and M is the speed rating which means 81 mph. 96 load rating means 1,570 lbs and 100 load rating is 1,800 lbs.

To install the Prodigy P3 Brake Controller #90195 all you will need is the wiring harness part #3040-P that you referenced. This adapter plugs into the 5-pin connector on your vehicle's built-in brake control wiring harness. The harness is…

I went out to our warehouse to measure the bracket for the Curt Spectrum Trailer Brake Controller #C51170 that you referenced and found that it has an outside diameter of just under 2 inches (1-15/16 inches to be exact). I have attached the image you…

The T-One Vehicle Wiring Harness part #118286 is what I recommend to add a 7-way to your 2017 Honda Pilot. The harness connects to the rear plug in the vehicle's hatch. This plug then runs through the length of the vehicle up behind the…

The correct way to pick out a weight distribution system is to base it off of the loaded tongue weight of the setup when it is loaded and ready to tow. This figure also includes the weight of any cargo behind the rear axle of the tow vehicle. I…

Yes, when installing the knob for the Redarc Tow-Pro Liberty Brake Controller item #RED24FR you will want to remove any extra material behind the insert. I am happy the video was able to help you out. I have linked a couple of pictures from the video…

To determine if a 2017 Toyota HIghlander has a factory towing harness, start by opening up the rear hatch. Then, lift up on the rear compartment panel and pull it out. Remove the two driver-side panels by pulling up on them. There, you may see a…

To prevent the need for any drilling or modification to your Highlander, I recommend using our No-Drill Long Mounting Bracket, #18136. This bracket comes with a steel clamp that will secure the bracket to the crosstube of the hitch. The bracket that…

If you have a vehicle specific wiring harness for a brake controller then that would indicate that you have a factory tow package and subsequently would already have a 7-way at the back of your vehicle. The universal 7-way connector #ETBC7 is meant…

You'd be fine to have a weight distribution installed on your trailer as you travel on the hill you described. If anything it might help prevent the trailer from leaning excessively. For a 6,000 lb trailer you'd be looking at a tongue weight…