Ventline RV Vents and Fans - Roof Vent - V2092SP-29 Review Video

In order to connect the Wall Control Panel #MA59FR to your MaxxFan Deluxe Roof Vent #MA00-07000K, you need the MaxxAir RV Wall Control Communication Cable #MA69FR. This part is not included with the roof vent or the wall control panel, so you will…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The top mounting hole measured center to center to the bottom mounting hole is 18". The overall length of the arm is 19 1/4". The mirrors are going to be a bolt on installation, it may require drilling if existing holes are not present. All…

Yes, the Dexstar Vintage Steel Wheel #AM20395 should work well for you. This is a 15 inch rim with a 4 on 9.44 inch bolt pattern like what you have.

I went out to the warehouse and pulled a MaxxAir Vent 64643 and a Ventline Ventadome Trailer Roof Vent, #V2092SP-28, and tested them together. The MaxxAir fits over the Ventline vent so the two are compatible. The MaxxAir cover was designed to fit…

The interior trim piece on the Ventline Trailer Roof Vent, part #V2092SP-28, fits roofs 1-7/8 inches to 3 inches thick. This unit should work just fine for you. I have included a link to a video review of the vent for you.

We offer a range of complete trailer vent assemblies, such as the Ventline #V2092SP-28 that you referenced, as well as replacement vent covers in various materials and colors. The Jayco website does not provide specifics as to the vent supplied with…

The Ventline Ventadome Trailer Roof Vent #V2094SP-30 that you referenced is an exhaust fan, what that means is that it pulls air out of the the trailer. The reason for this is that hot air rises, so when you pull out the air at the top of the trailer…

I went out to the warehouse and the thickness of the rough opening in the roof for installing this vent can be from 1-7/8 inches to 3 inches.

The fan itself only fits onto the motor one way. If you wanted to reverse the rotation of the fan you would need to switch the positive and negative leads on the back of the motor. I tried this with just the motor and it will reverse the rotation.…

It sounds like you are talking about the ceiling garnish. I have included a link to the ones that we carry to the right. But they are all 14-1/4 inches square. This is the measurement of the part that fits in the opening though, not the overall width…

We have the B and W 2-1/2 inch to 2 inch hitch adapter part #BWRHXA2182 which has two sets of pin holes at different depths to install more flush like you are wanting. One set of the holes was specifically designed for the Ford hitches like you…