Review of TruRyde D Washer For EZ Lube Spindles - 5-23 Video

Since you need 10 inch by 2-1/4 inch hydraulic brake assemblies that have a 4 bolt pattern that is 2-7/8 inches the drum brake kit part #AKUBRK-35-D would be what you'd need. The bolt pattern you mentioned is the standard 4 bolt pattern.

90-120 ft lbs of torque is probably about right for your trailer rims. If you check out the lug nut torque chart that I attached you will see that nearly all of the torque specs are that and higher.

There are many ways you can secure wires to a trailer. I would not recommend the use of tape as it will wear out quickly when exposed to the elements. Soldering is also not recommended because it is a more permanent method and you may need to change…

The TruRyde Replacement D Tang Spindle Washer #5-101 that you referenced has a 1-inch inner diameter to fit on 1-inch diameter spindles. All such items that we offer share this same 1-inch inner diameter, such as parts #5-23 and #5-57. The points on…

Yes, you can simply use the nut retainer part #6-191 on your spindle nut instead of the tang washer setup and it would work just fine. The EZ lube fitting would not be an issue at all.

Yes, we do have replacement spindle nuts and washers. I have included links to all of the options we carry. We have 2 different D-washers. First, #5-23 is designed for 3.5K to 5.2K axles. And #5-57 is for 6K to 8K axles.

Thank you for your purchase of the Electric Trailer Brake Kit w/ Dust Shields part #AKEBRK-10. In some cases, you can remove the spindle nut with a set of channel locks but in others you will need to use a socket and ratchet or even possible a…

Trailer wheel lug nuts that are 1/2-inch inside diameter typically have a 20-TPI thread pitch (20 threads per inch). Most lug nuts also use a 60-degree-coned profile like #CE11051, but a 90-degree like #STN569 is also available for 9/16-inch studs.…

The 5 on 4-1/2 bolt pattern of a hub or wheel such as #AM20365 means that there are 5 lugs and, if you drew a circle that passed through the center of each lug the diameter would be 4-1/2 inches. I have included some links and a picture that will…

I went ahead and double checked to be sure, and yes the 7-Piece Installation Set for Bearings, Races, and Seals #PTW83020 you mention will work with your Timken bearings, races, and seals. If you don't have grease yet, you're also going to…

The Replacement Spindle Washer #5-101 referenced in your question is designed for 1 inch, D type spindles. The washer will install right between the castle nut and outer bearing, and the tang on the washer is bent up to prevent the nut from turning.…

You can mount the Castle Rock ST235/80R16 Radial Trailer Tire #LHCK401 on any of our available 6 lug wheels for your spare tire as we do not have any tire combos with the Castle Rock in a 6 lug. Here are a few steel 6 lug wheels that are the correct…