TryRyde Tang Type Replacement Spindle Washer Review Video

Hey Tim, thanks for the picture of your current brake assemblies. While what you have doesn't look exactly like a free-backing setup you definitely can replace what you have with them. For that I would go with the etrailer part #AKFBBRK-35…

The biggest difference between the servo styles that you'll notice is between free backing plates and the others. The free-backing plates will allow your trailer to back up without having the brakes lock up. With surge brakes typically when…

The Never Fail Bushings like part #TRBU11566 and the Bronze Bushings like part #D014-077-00 are designed for 1-3/4" wide double eye leaf springs. There is not a version of these which are an upgrade over the factory nylon bushings for…

A replacement tang-style spindle washer like part #5-101 is intended to be installed behind the castle nut and have its prongs bent down so that they prevent the castle nut from rotating on an E-Z Lube type spindle. The castle nut holds the washer…

You'd want the tang washer like the #5-101 that you referenced between the washer and the nut.

The inner diameter of the Stainless Steel Drive-In Grease Cap w/ Plug #DE69YR measures 1-7/8" (see attached).

Uni servo and duo servo is basically the style of wheel cylinder. It basically puts pressure on either side of the cylinder. The styles are interchangeable so if you have one style over the other you can go with either style. As long as your drum…

That will depend on what actuator and brake assemblies you have installed on your trailer. Your best option would be to check out the link I attached that has all of the actuators we carry so that you can identify what you have and then check out…

Since the D60 Dexter Axle uses a cotter pin and castle nut the #RG05-100 would not be the correct kit for you. For that I would recommend the Trailer Spindle Nut #165686. For a compatible cotter pin I would recommend the Cotter Pin part #165649.…

We currently offer several different spindle washers and I have included a link to them for you. However, none of then have an inner diameter of 1-1/16 inches. I recommend using a set of digital calipers to take the measurement because it needs to be…

To determine the correct brake kit you'll need to measure the diameter of the brake pads (from one side of the assembly to the other). If it is 10" and you have hydraulic brakes then I recommend the Titan Free Backing Kit #T4071600-500, but…

What it sounds like is happening with the Dexter Hydraulic Brake Kit - Free Backing - Galphorite - 10" - Left/Right Hand - 3,750 lbs #T4423500-400 locking up when wet is the shoe has likely absorbed moisture and expanded, causing the lock up.…