TruRyde Trailer Bearings Races Seals Caps - Bearings - BK3-210 Review Video

Yes, the bearing kit part #BK3-210 does fit a good portion of the 7,000 lb Dexter axles out there, but some of the 7k Dexter axles require a slightly larger grease seal which instead requires the kit part #BK3-200. What you'll want to do is…

I contacted Lippert to confirm bearing sizes and it sounds like your 7,000-lbs axles have an outer bearing like Item #14125A and an inner bearing like Item #25580 and a 10-36 seal. Based on this information, I recommend the replacement Bearing Kit,…

Yes, because it is a 3-wire light, you can wire the Red Identification Light Bar with White LED Utility Light #OPT88FR to function as rear marker and reverse lights.

We do not carry a tool that will help install your races, though I can pass on some information for you that might be helpful. To install your races, this is what you'll want to do, according to our help article on replacing bearings, races and…

The correct bearing kit for your 7,000 pound Lippert axle is #BK3-210.

You can verify that the 10-19 grease seal included in Bearing Kit #BK2-100 is the correct one for your spindles by taking two measurements. First you want to measure the rear hub bore where the seal is inserted. The seal's outer diameter needs to…

When installing a seal at the back of a hub the outer part of the seal will need to be flush with the hub. I have linked a video that should help. You could watch the whole video or fast forward to the 1 minute, 50 second mark to see the seal…

Yes, Lippert and Dexter 7k axles use exact same bearings. The only issue you might run into is a difference in grease seal size required. There are two sizes of grease seals that fit 7k axles and there isn't a rhyme or reason as to which you may…

The HydraStar Disc Brake Kit w/ Actuator for Triple Axle Trailers - 13" Hub/Rotor - 8 on 6-1/2 - 7K #HYD54FR comes with all of the brake lines needed to install this kit on your 2017 Heartland Road Warrior 413, so you don't need any…

The bearing kit you need for your Lippert 7,000 lb axles is Bearing Kit #BK3-210. This kit contains the correct bearings, #25580 and #14125A as well as the matching races and grease seal #GS-2125DL.

The correct lug nut torque range for a steel trailer wheel like the Taskmaster Provider ST205/75R15 Radial Trailer Tire/Wheel #TA47VR is 90 - 120-ft-lbs. This tire should be inflated to the full 50-psi cold pressure rating noted on the tire sidewall.…

Based on my research your M1101 trailer has a GVWR of around 3400lbs, so for a replacement axle I recommend taking a look at the Timbren Heavy-Duty Axle-Less Trailer Suspension - Straight Spindle - Off-Road Tires - 3,500 lbs #ASR35HDS01 which will…