Review of Trailer Valet Trailer Jack - JXS Side Mount Sidewind Trailer Jack - TV64FR Video

The mounting plate for the Trailer Valet JXS Trailer Jack #TV64FR has bolt holes that are separated on center 5-1/2" horizontally. The vertical mounting holes are separated on center 1" each for a total of 5" from the top…

Thanks for the picture. I went ahead and checked out what we have that matches that style of plug, and unfortunately we do not have anything that matches what you are needing. The closest 3-prong wire we have is the 3-Wire Pigtail for Trailer Tail…

You can use the Trailer Valet JXS part #TV64FR on an I-beam trailer frame but it would need to fit around the I-beam instead of fitting into it.

I do have a great option for you, however we do not have any standard 3,500 pound round tube axles available that match the dimensions you provided. For an exact replacement your best option will be to go through a local trailer shop or the…

On each individual electric brake magnet the amperage draw would be 3.0 to 3.2 max amps at 12 to 13 volts on 7-inch brake magnets and 3.2 to 4.0 max amps at 12 to 13 volts on 10 and 12-inch brake magnets. The max amperage draw for the brake magnets…

I will start with the hubs. You have Dexter 8-248 hubs so the correct replacement is the Dexter Trailer Idler Hub Assembly for 3,500-lb Axles - 5 on 4-1/2 #84545BX. This assembly includes the bearings, races and seals. For Bearing Buddy replacements,…

The brackets included in the Fulton #F500286 Replacement Jack Mounting Hardware measure 6-5/16 inches long by 1-5/16 inches long. The hole spacing between the closer holes is 1 inch, the spacing between the group of 4 holes and the further away hole…

It sounds like you may have a ground problem on your Husky. The jack is grounded through the mounting hardware so you want to make sure the mounting hardware is making good contact with clean, corrosion-free surface on the trailer. The jack has one…

The most probable cause for the lights on your Ultra-Fab electric tongue jack to blink, and for the jack not to operate, is a weak battery and/or grounding problem. This jack grounds through its round mounting flange which contacts the trailer frame.…

There is a couple things you can try to get your Husky Brute 4500 Working again. If the light are coming on and the switch is just clicking you would need to check the star washers on your ground. Remove the ground wire from the frame and scrape the…

The inner diameter of the replacement mounting bracket for Trailer Valet part #TV-0002 is 2-1/2 inch. The pin diameter is 5/8 inch.

It is likely that the interior gears have stripped when the jack over-extended. If you have the manual crank that should have came with the jack, use it by removing the rubber plug at the top of the jack, insert the crank and fit it to the override…