Tekonsha Brake Controller 3041-P Review Video

If your trailer has 7 wires running all the way back to the brakes, then yes, you can tap into the existing wiring. Each of your new brakes will have two wires for the brake magnet. One wire is for 12 volt power to the brake magnets and the other…

Something might got miss-wired most likely when you replaced the old 7-way with the part #H20046. Since there are two different color codes for 7-way trailer wiring this isn't super rare. Check out the diagram I attached that shows how the two…

Hey David, I have an alternative solution for you to connect your Tekonsha Prodigy P3 #90195 brake controller to the tow package wiring on your 2016 Toyota Sequoia, but right now the parent company of Tekonsha was bought out and nobody knows…

What you're seeing on yours just indicates that a trailer is connected and the boost is active, but the controller will go into sleep mode after 15 minutes of inactivity. The controller doesn't turn completely off, but the power drain in the…

If you have a vehicle specific wiring harness for a brake controller then that would indicate that you have a factory tow package and subsequently would already have a 7-way at the back of your vehicle. The universal 7-way connector #ETBC7 is meant…

For the Redarc Tow-Pro Elite Trailer Brake Controller #RED44FR is an easy installation with the Tekonsha Wiring Harness #3041-P. You will just use the white connector of the harness along with the wire length and cut off the other end of the…

The three items you mentioned are all that's needed to install the Redarc Tow Pro Liberty part #RED24FR in your 2016 Toyota 4Runner with the tow package: #RED24FR #331-TPSI-002 #RED49FR

The additional white wire on the Tekonsha Pigtail #3041-P is required to be grounded as the factory ground wire has proven to not make a strong enough ground connection on your 2019 Toyota 4Runner. We do offer the Adapter #331-TPH-017 which will…

For sway control on your 2017 T@B 320-S I recommend the Reese Friction Sway Control Kit #83660 because it will keep your T@B stable and allow you a more comfortable towing experience. Using the Reese kit gives you control over your trailer and…

I have a replacement option for you, but the only slipper spring we offer that is 1-3/4" wide and is 26-1/4" long is the 4-Leaf Slipper Spring w/ Open Eye End for 4,300-lb Trailer Axles - 26-1/4" Long #e33SR. Since you mentioned that…

Although we do not have spacer blocks of that dimension we have an option for you that will allow you to lift your trailer with what is called an over/under conversion kit. This moves your trailer's leaf springs to the top of your axle and lifts…

From center hole to center hole, the shackle straps measure 3-1/8 inches on the hanger kit you asked about: - Single-Axle Trailer Hanger Kit for Double-Eye Springs #APS4 The kit also uses 3-1/4 inch tall front hangers, 1-1/4 tall rear hangers, and is…