Customers compare BLU67FR to these similar products
Products Featured in this Video
Hi there. I'm Michael with etrailer.com. Today, we're gonna take a quick look at this Blue Ox TrackPro Weight Distribution with sway control. I'm gonna go over some of the features and kind of compare it to some of the other weight distribution systems that we have here at etrailer.com. So if you're not familiar with what a weight distribution system is or does, basically this is going to help… see more >
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
An underslung trailer coupler is one that attaches to the bottom of the trailer frame and an overslung one is one that attaches to the top of the frame. Measuring is not required if you just take a look at your coupler and see where it attaches to…
view full answer...A weight distribution system would be a good choice for you. We recommend using one whenever the weight of the trailer exceeds half of the vehicles towing capacity. You are almost there with the weight of your trailer so it would be recommended.…
view full answer...We can help you out here, and first, thanks so much for the photo it was super helpful. And based on that I can tell you that your tandem axle trailer with #10 Torflex axles is absolutely compatible with the Dexter lift kit: - Torflex Lift Kit -…
view full answer...Great Question. Underslung couplers on trailers look like the trailer frame is sitting on top of the coupler. For an example of what one looks like check out the etrailer.com A-Frame Coupler Underslung #CA-5335-B. I attached a picture of one for you…
view full answer...We do offer the Blue Ox SwayPro Weight Distribution Systems for underslung trailer couplers; part #BXW0553 for 6K, part #BXW0753 for 8K, part #BXW1003 for 10K, and part #BXW1503 for 15K. Unfortunately, they aren't offered with 2-1/2" shanks…
view full answer...The trailer tire size 215/75R14 that you have can fit on a 5.5 inch wide or 6 inch wide trailer wheel so either width will work fine. So the galvanized wheel part #AM20364 would fit and work well.
view full answer...Thanks for the picture! The Curt TruTrack 2P Weight Distribution System w/ Sway Control item #C69JR will work with your 7,000 lbs Jayco 267BH. The Curt TruTrack has an 800 lbs to 1,000 lbs tongue weight range. The built in sway control will help to…
view full answer...The Dexter Torflex Lift Kit #K71-707-02 referenced in your question is designed for the #10 Torflex axle with a 2,300 to 4,000 pound capacity. As you mentioned, the lift kit cannot be used with Torflex axles that use a 3 inch high profile bracket.…
view full answer...The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
view full answer...Torflex Lift Kit - Tandem Axle - 2-5/8" Lift Item #K71-707-02 doesn't require that you have your axles aligned after installation but it is good practice to do so. It is actually easier than you might think. Basically, measure from center of…
view full answer...We actually have had customers make the swap from rubber valve stems to metal valve stems so they can use the TST TPMS for RVs - Color Display - Signal Booster - 4 Flow Through Tire Sensors #TST-507-FT-4-C. I added the cut out of that review for you…
view full answer...It is certainly possible for any axle to wear out enough over time to need replacing. Since the suspension is built into a torsion axle if the suspension part was to wear out pretty much the only solution would be to replace the axle. If the…
view full answer...