Reese Weight Distribution RP54980 Review Video

The replacement parts you are seeking is the Replacement Head and Shank for Reese Weight Distribution Systems - Trunnion Bar #RP54980. This will work with your Reese Strait-Line Weight Distribution System. If you need more drop in the shank, then you…

Curt recommends the use of 250 ft/lbs of torque when tightening the nuts of their hitch balls with a 1 inch diameter shank like the part #C40034 that you referenced. The general rule is for a 3/4" shank tighten to 150 ft/lbs For a 1" shank…

There could be one of two things that is not allowing your awning to extend. The first of which as you mentioned is a wire short so be sure to open up the head and pull the switch to look for loose or broken wires. If none are found then there could…

I've attached the pairing instructions for the Furrion DV7200 below to help with the process.

I can explain it. The use of a 5th wheel to gooseneck adapter such as #CAB-C5G increases the distance from the trailer frame to where it couples to the gooseneck ball. The distance is greater in this instance compared to having the trailer coupled to…

I recommend the Kenda Karrier ST205/75R15 Radial Trailer Tire with 15" Black Mod Wheel - 5 on 4-1/2 - LR D #AM32424 which are rated for 2,150 lbs at 65 psi but are also rated for speeds of up to 81 mph. I have added a link to a video review to…

The Furrion RV Stereo #DV3300SBL can be paired to your smartphone by completing the following steps: 1. Activate Bluetooth mode on your mobile device. Then press the Bluetooth button on the front panel of DV3300S to enter pairing mode. 2. When…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Basically with any weight distribution system/sway control you can back a trailer up with it installed IF you only plan to back up mainly in a straight line. If the trailer has to be jackknifed at all then you have to disconnect the setup. The rule…

For chain hangers or your Draw Tite weight distribution system we have the clamp on set part #RP58306 or we have the bolt on set part #RP58305. Either of these would work great with your Draw Tite system.

For a Fastway e2 weight distribution system the correct head for a 12,000 kit would be the #FA92-02-1255 that you referenced. This matches the picture you attached. Then for replacement spring bars you'd need #FA92-01-1299.

Since your dry tongue weight is a bit more than 10% of total weight, we will assume the same for loaded and estimate that you have a 900 pound tongue weight loaded. I prefer the pro-active, dual cam sway control systems to the reactive friction…