Redline Trailer Brakes BRKH10A Review Video

Yes, the DeeMaxx Disc Brake Kit #DE66YR will allow you to use 14" trailer wheels.

Yes, the Hydrastar Vented Electric Over Hydraulic Actuator, #HS381-8067, will work with the factory brake controller on your 2011 Ford F-350. The earlier Ford brake controllers had trouble with these types of system, but Ford changed the brake…

In order to replace your boat trailer surge coupler you will need to match a number of your trailer's characteristics. You need to select a coupler for the type of hydraulic brakes you have, either disc or drum. Couplers for each type vary in…

Brake calipers are typically installed so they point toward the back of the trailer, but it is okay to install them pointing up or toward the front of the trailer. The important thing to consider when installing the calipers is to make sure at least…

The DA91 Demco surge brake actuator that you are looking for is part #DM8750311. This has a 2-5/16" coupler, comes with an electric lockout, is designed for disc brakes, and has a weight capacity of 8,000 lbs towing and 800 lbs tongue weight.

There is a good way to get the check valve out of your current actuator and save some money. What you will need to do is remove the large snap ring from the front of your actuator where the brake line attaches, pull the spring out, and at the end of…

I believe you need the 4-Leaf Slipper Spring w/ Open Eye End for 4,300-lb Trailer Axles #e33SR which measures 26-1/4" from the center of the spring eye to the end of spring.

The 4-Leaf Slipper Spring #e33SR that you referenced actually comes included with the nylon bushing but if a replacement is needed then the 9/16 inch #TRBU11561 that you mentioned would be the correct size and will work perfectly. The correct bolt…

The 4-Leaf Slipper Spring w/ Open Eye End for 4,300-lb Trailer Axles - 26-1/4inch Long Item #e33SR that you referenced does not require an additional bushing for the hook end to attach to the rear hanger. The hook end of the spring will rest on the…

You can use leaf springs that are rated higher than the axle without any issues as long as they measure the correct measurement for your trailer. For example the 6-leaf double eye spring for 7,000 lb axles part #e64SR measures 24-7/8" eye to…

As they wear, leaf springs tend to flatten out. The first step is to get the correct length of the existing springs. In order to do that, you'll need to put the trailer up on jack stands and measure them (center eye to center of the slipper) with…

Have you tried tapping the bolt in with a hammer? Hopefully not much force would be needed. Ideally you get the splines seated all the way but then you don't have to really torque the nuts down as the bolt needs to allow the suspension to move.…