Customers compare 882K-7 to these similar products
Products Featured in this Video
Today we're going to take a look at the Peterson Luminex LED trailer light kit. This is going to have your stop, tail, turn, and backup lights and it's going to have a round design with a red and clear lens.This is going to be a very multifunctional light. We'll have our red lens with a small little cut out there that's going to have a clear lens. So that'll act as our backup signal and then the… see more >
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
The only round, recessed mounted tail light we offer with four functions (tail, stop, turn, and reverse) is the LumenX LED Trailer Tail Light part #882K-7 which has LEDs so it will be bright. I have attached a video for you which shows the light in…
view full answer...In order to wire your cargo trailer for both 12 volt DC and 110 volt AC power you would need to install a AC/DC distribution panel and power converter which we currently do not offer. You would then wire the 12 volt power to the converter along…
view full answer...Yes, the 7-Pin Round connector is wired differently than the 7-Way flat RV connector. I will list the typical heavy duty truck wiring connections inside the plug on the trailer side for you. At the index guide for plugging the trailer end in to the…
view full answer...I attached a picture that shows the pin out diagram for the Pollak 5th Wheel / Gooseneck T-Connector with 7-Pole #PK11893-11932 that you referenced.
view full answer...I have exactly what you are looking for, #STL201RFMB. This light is DOT-compliant, offers sonically sealed weathertight connections, and has a recessed flange mount design for secure installation.
view full answer...Truck with 4-wheel drive tend to be taller than there 2-wheel drive brethren and add to that the fact that truck manufacturers make the bed sides taller and taller every generation and its no wonder clearance can be an issue! We usually tell…
view full answer...It sounds like your trailer tail lights you are using now ground through the mounting hardware. That would be why there are only 2 wires. One of those two wires is going to be for turn signal/brake lights and the other is going to be for running…
view full answer...Most likely, the trailer would be rated for 7,000 pounds gross if it has two 3,500 pound axles. But there should be a sticker or plate somewhere on the frame near the front of the trailer that lists its official capacity. Also, the trailer can only…
view full answer...I went out to the warehouse and pulled the Optronics #STL201RFMB light to test it out and see for you. I found that when you have the running lights on that the LED ring glows constantly. When you press the brake, the red LEDs and the red LED ring…
view full answer...Unfortunately, we don't offer any 6 bolt brake assemblies all the brake assemblies we offer for a 10K axle use a 5 or a 7 bolt mounting flange. According to Dexter, they discontinued those brake assemblies about 20 years ago. The good news is…
view full answer...You can absolutely install an aftermarket trailer brake controller to your 2021 Chevy Silverado 1500 with the factory tow package, so whoever told you that had some bad info. And since you have the factory tow package you can simply add a plug and…
view full answer...The Redarc Tow-Pro Liberty #RED24FR is the way to go over the Elite #RED44FR as you get the nicer functions of the Elite at a lower price. The Elite has the ability to be the more preferred proportional style of controller as well as a time-delayed…
view full answer...