Peterson Trailer Lights - Tail Lights - 435800 Review Video

So what you have currently is our part #435800 which we have a replacement LED style light for with the part #M826R-7. For an install grommet you'll then want the part #426-18 and for a wiring harness part #431-491 and you'd be set.

I wasn't able to find much detailed information on the Signal Stat 9031 model light assembly that you mentioned other than that it has been discontinued. In order to see if the Peterson Light Red Flush Mounted Turn Signal #435800 will work well…

The green wire from the controller attaches to the cold side of the brake stoplight switch, the white ground wire attaches to the negative battery terminal, the red wire supplies 12-volt power to the controller, and attaches to the positive battery…

There isn't one on an 2021 F-250. A PL3 plug is the connector behind a trailer light. That's what the Peterson Load Resistor Harness for LED Turn Signals item #421-491RS plugs into. You need to use one per light. If your trailer's lights…

The trailer will have a plate or sticker on it that will list the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that will list the weight capacity. You can…

There are several items you might want to try using for removal of corrosion in your 7-way trailer connector, like part #HM48480. White Vinegar A wedge shaped, slip on pencil eraser or art gum eraser Pipe cleaners PB Blaster If the corrosion is…

There are a wide variety of trailer lights offered and these come with different type of construction. Some lights may not be user-serviceable (such as some LED types and sealed waterproof lights) but usually trailer lights that use standard…

Both the Rubber Grommet #A45GB and the Notched Rubber Grommet #A45GNB that you referenced will fit and work well with the Optronics 4" Round LED Light #STL55RB. The only difference between the two grommets, as you mentioned, is the notched cut…

The difference is that the grommet part #A45GNB has a notch cut in the lower portion that seals to the mounting hole. This allows the grommet to install a bit easier than the part #A45GB.

Hello Franklin. Unfortunately, we do not have any kind of 3D model of the Peterson Trailer Tail Light #435800 that we can send you. Most trailer light manufacturers do not make these kind of models for their parts. We do have some more basic…

To lubricate your Collar Lok coupler the white lithium grease part #58117 would be what you would need. Any degreaser like Simple Green can help take off the old grime and grease.

Although the DOT numbers you gave me are codes for what testing was done on the lights, I do have a solution for you. For your 2-1/2" round clearance light we have the Peterson Piranha LED Light #162R with the wiring and grommet as part…