Can the Hopkins LED Breakaway Switch # HM20060 be Used with a Trailer Battery
Question:
Hello- I have a Coleman popup camper that has a battery. The battery is charged via the tow vehicle. I would like to get a breakaway switch that does not have its own battery since I already have one that will be maintained. Can I use this switch with my existing battery? Thanks
asked by: Kelly
Expert Reply:
Yes, you can use the Hopkins LED Breakaway Switch, # HM20060, with your existing trailer battery as long as the battery is a 12 volt and can power the trailer brakes at or above DOT specifications. On the switch, the black wire will be connected to the positive trailer battery terminal, the white wire will be grounded to the trailer frame or to the negative battery terminal. The blue wire will attach to the electric brake wiring.
In some states, a break away system is required by law to have its own dedicated battery. Check with state and local regulations to see if your area has such a law.
Product Page this Question was Asked From
Hopkins Pull to Test Breakaway Switch with 48" Long Cable
- Accessories and Parts
- Trailer Breakaway Kit
- Switches
- Hopkins
more information >
Continue Researching
- Search Results: trailer lights
- Search Results: trailer light wire
- Shop: Bargman 7-Way, RV-Style Connector w/ 6' Long Coiled Cable - Trailer End
- Shop: Combination LED Trailer Tail Light - Submersible - 6 Function - 11 Diodes - Passenger Side
- Shop: ONE LED Trailer Tail Light - 7 Function - Submersible - Square - Red Lens - Driver Side
- Search Results: break away switch
- Shop: Hopkins Pull to Test Breakaway Switch with 48" Long Cable
- Video: Hopkins LED Breakaway Switch Installation
- Video: Hopkins Smart Light Submersible Trailer Tail Lights Review and Installation
- Video: Hopkins 7 Way Molded Trailer Wire Connector Installation
- Video: Optronics Trailer Lights - Clearance Lights - MCL93RB Review
- Video: Optronics LED Identification Light Bar Installation
- Search Results: 12 gauge brake wire
- Video: Bargman Wiring - Trailer Connectors - WG54006-043 Review
- Video: Bargman 7-Way RV-Style Connector with Coiled Cable Review
- Search Results: trailer ramp
- Shop: Hopkins 7-Way RV Style Connector with Molded Cable - Trailer End - 8' Long - RV Standard
- Shop: Hopkins Smart Light Trailer Tail Light w Testers - 6 Function - Submersible - Passenger's Side
- Shop: Hopkins Smart Light Trailer Tail Light w Test Lights - 7 Function - Submersible - Driver's Side
- Q&A: Can a Breakaway Switch be Wired Directly to the Trailer Battery Rather Than the Breakaway Battery
- Q&A: Can Trailer Breakaway Kit be Used without a Battery
- Q&A: Installation of the Hopkins LED Breakaway Switch # HM20060
- Search Results: break away switch wiring
- Q&A: Where do the Wires of a Trailer Break Away System Install Onto
- Q&A: Troubleshooting Door of Bright Way Trailer Breakaway Kit Not Able to Fully Open
- Q&A: Recommended Complete Flat Towing Setup for a 2021 Chevrolet Blazer
- Q&A: Troubleshooting Trailer Break Away System
- Article: Pintle-Hitches
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Trailer Wiring Diagrams
on Accessories and Parts
