Review of Lippert Components Trailer Jack - Camper Jack - LC314667 Video

The mounting holes are 16-1/4 inches apart on the Curt hitch, part #C15845. Also the rivet holes are 3 inches apart. I've included the diagrams of all the mounting hole measurements for you. As well as the install details of the hitch.

You are correct, the Replacement Footpad Kit #LC86UD is mounted with the bolt, flat washer, o-ring, footpad and finally the 2nd o-ring before threading into the base of the hydraulic jack.

Yes, The Curt Class V Trailer Hitch Receiver part #C15845 will fit all models of the 2019 Ford F-550 Cab and Chassis with 34" wide frames outside to outside.

I would be happy to help! The Curt Trailer Hitch Receiver #C15845 you were looking at is designed to fit the 2003 Ford F-350/450/550 Cab and Chassis motorhomes, and will not work on your 2003 Thor Four Winds Hurricane built on the Ford F53 chassis.…

If you are needing to extend the gap between your tow vehicle and trailer, the Roadmaster Anti-Rattle hitch Extender #RM-071-1075 referenced in your question will provide a great solution. This is compatible with any 2 inch hitch receiver and will…

We do have a large selection of hitch extenders that will allow for the needed clearance between your tailgate and jack. The shortest extender we have available for 2 inch receivers that has the required capacity for your 8,000 pound trailer is the…

The Roadmaster Htich Extender #RM-071-1075 measures approximately 3 inches deep from the pin hole to the furthest point inside the receiver tube. It's also only designed to be used to flat tow a vehicle with a hitch style tow bar. It can't be…

Yes, axle spread and wheel base by definition are the same measurements. You will measure from the center of one axle to the center of the 2nd axle to determine what you axle spread is. This may be difficult as some wheels and covers will make this…

The replacement Foot Pad for Lippert Hydraulic Ground Control Leveling System - Qty 1 #LC324269 needs to be torqued to 132 ft-lb and Lippert recommends using some Loctite Threadlocker 262 - High Strength - Up to 3/4" Nuts/Bolts - 0.20-Fl-Oz Tube…

The Replacement I-Beam Jack Bracket part #LC349975 is a direct replacement for Lippert Ground Control 3.0 Jacks part #LC358590 and part #LC675817. The bracket is ideal for eight inch and ten inch I-beams so if your I-beam is 8 inch or ten inch this…

I attached a dimension picture I got from Lippert for the Replacement I-Beam Jack Bracket #LC349975 that you referenced.

The 9" Round Foot Pad #LC314667 is actually meant to be used to replace rectangular 5th wheel RV landing gear foot pads. Since most rear foot pads connect to a round tube you are probably going to need part #LC377962 instead.