Can the 9" Round Foot Pad # LC314667 be Used for Rear Jacks

Question

Question:

The write up mentions front. Are these the same for the rear?

asked by: Howard D

0

Expert Reply:

The 9" Round Foot Pad # LC314667 is actually meant to be used to replace rectangular 5th wheel RV landing gear foot pads.

Since most rear foot pads connect to a round tube you are probably going to need part # LC377962 instead.

expert reply by: Jon G

0

Answer 1

For a single axle trailer, you want the shackle strap to be able to move so that you have the spring deflection needed for your suspension. Angled like the photo or even almost vertical is fine you just don't want the shackle strap to bind…

view full answer...

Answer 2

There is no specific torque rating for shackle bolts. Basically for the middle bolt there should be enough free play in the shackles to allow them to move. Tightening the shackle bolts too much will squeeze the shackle straps against the leaf…

view full answer...

Answer 3

I have attached for you below some common torque values needed for a trailer suspension system but a lot of these will vary by bolt size and other factors. U-Bolts: Varies by Size - 1/2" bolts: 45 ft/lbs - 70 ft/lbs, 9/16" bolts: 65…

view full answer...

Answer 4

Lippert Components JT's Strong Arm #LC191025 is designed for use with travel trailers whereas #LC191024 is designed for 5th wheel trailers with less than 58 inches between the landing gear jacks.

view full answer...

Answer 5

Hey Kevin, so the Bearing Buddy part #BB2717SS does fit the Lippert 7k axle so it is the correct size BUT you will need to yank the zerk fitting off your EZ lube style spindle. I would first try putting vice grips on the zerk so that you can focus…

view full answer...

Answer 6

You are correct, the Replacement Footpad Kit #LC86UD is mounted with the bolt, flat washer, o-ring, footpad and finally the 2nd o-ring before threading into the base of the hydraulic jack.

view full answer...

Answer 7

Thank you for reaching out and for the photos! We try to carry over the wiring brackets and for a long time they didn't change which is why we carried it over. With this new information we will definitely be updating our website. For your…

view full answer...

Answer 8

I attached a chart that has all of the recommended lug nut torque specs for trailer wheels. Based on your studs being 1/2 inch, your wheels being 15 inches in diameter, and your lug nuts being coned you would want to torque your lug nuts to 90-120…

view full answer...

Answer 9

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights…

view full answer...

Answer 10

The exact replacement foot plate for the Level Up system you have is not available as a replacement. But you could use #LC314667. The issue is that it uses a smaller bolt than the Level Up foot. So you would have to use a 1/2 inch bolt that will…

view full answer...

Answer 11

The feet on your motorhome's landing gear should not be bent at all, and for a SnapPad like the SnapPad XTRA Jack Pads for Lippert Leveling Systems w/ 9" Round Jack Feet #SP54FR4 you're looking to fit, it's going to…

view full answer...

Can the 9" Round Foot Pad # LC314667 be Used for Rear Jacks

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching