Lippert Components Trailer Suspension LC283280 Review Video

I will be happy to explain how to install the shock kit #LC281281. In addition to the instructions below I have also included a picture of the actual instructions. 1. Raise trailer and jack up the axle to release pressure on the springs. 2. Remove…

According to my research, the Marshall HP424 does have a Type 1 connection (which connects to your propane tank) and a 1/4" Male NPT connection (which connects to a dual-stage regulator). So the hose you mentioned will work as a replacement, and…

I have done a bit of research and it sounds like you need the hose that goes from the propane bottle to the regulator. We have 3 different lengths of the MB Sturgis Propane Hose Assembly. We have 12", 15", and 20" lengths. - MB Sturgis…

The best way to determine which replacement shocks will work is by matching up the length of the old ones as close as possible and then also using the GVWR of the trailer. If your brackets are 12-1/2" apart, and the GVWR of your trailer is…

If you are looking to add shocks then measure using the following procedure: Compress the shock all the way (A) then mark the inner leg where the outer leg stops. Then release compression and measure the stroke (how far the shock moves) (B). Then…

Yes, the Lippert Heavy-Duty Replacement Shock #LC283280 will fit your 2022 Jayco Eagle 321RSTS. We have had this question come up in the past in relation to the Jayco Eagle 321RSTS and we have been able to verify that they do fit.

We have shock #LC283280 but its compressed length is 8-5/8 inches. We are measuring that from inside washer to inside washer though so if you are measuring differently it is possible that this shock will work. I have linked a video of this shock for…

When installing a shock kit like the Lippert Bolt-On Shock Kit w/ Heavy Duty Gas Shocks - 5,200-lb to 7,000-lb (3") Axle #LC281281 or using the #LC283280 you will want to install the shock so the lower connection to the axle U-bolt plate happens…

Yes, I would recommend keeping the bolts of the #AP233 lubricated. An easy way to do this is to use wet bolts like part #126B2 which have a zerk fitting that allows for easy application of grease to them.

The Lippert Heavy-Duty Replacement Shock #LC283280 does included new rubber bushings, washers and nuts to mount to the shock. Be sure that your brackets are spaced properly to accept these shocks. The shocks have a compressed length of 8-5/8"…

I do have an option for you. Due to the length of your 5th wheel and size of your bumper, we do not have a bolt-on option available. That being said, you can use the Ultra-Fab Steel Jumbo Roller for Trailers and RVs #UF48-979023 which is a weld-on…

Thank you for providing a photo diagram of your 5th wheel rear frame area where you are intending to install Ultra-Fab Steel Micro-Roller Skid Wheels #UF48-979021. The best location to weld on these rollers is at or just behind the point where the…