Hydrastar Brake Actuator - Electric-Hydraulic Brake Actuator - HBA16 Review Video

It's not common for the spindle number to be printed anywhere on the axle. That said, if you're looking for new bearings/races and seals all you need to do is note the capacity or measure. The easiest method would be to crawl under…

There actually is no real difference. They have the same dimensions, fit the same applications, and are both double lip seals. Our part number for the 10-36 is the #RG06-070.

Yes, you can upgrade your 24' enclosed trailer's 5,200 lbs axles to 7,000 lbs straight axles. You'll need to upgrade your trailers suspension components, hubs, and wheels/tires. You will want to measure your current axle to…

Thank you for those measurements they were great and we do have the hub and drum you need, you just need to know if you need a 6 lug or 8 lug hub, as well as your axle's weight capacity, though it should be between 5,200 lbs and 7,000 lbs. -…

You will need to measure the diameter of the spindles where the seal and bearings ride. Check out the picture I attached that shows where this is. You will need an exact measurement so either a digital or dial caliper will be needed. To pick out the…

It might be possible to change out the studs in your hub from 9/16 to 5/8 if they are drive-in studs and not the type that threads in. If they are drive in and the diameter of the knurl end is approximately 0.6875 inches then you can replace them. We…

While we do have the disc brake hub and rotor for a 3,500 lb axle, we do not offer torsion axles, or any axles of the length you need. But for the hub and rotor brake kit that has a 5 on 4-1/2" bolt pattern and works with 14" wheels…

The mounting brackets of the Kodiak kit like the #K2R526D and the Dexter kit part #K71-647-648 locate the caliper relative to the hub in a slightly different position as well as use different bolt hole dimensions. Because of this the two kits…

Thanks for the pictures and info on the EZ Flex equalizers of your 2014 Heartland Cyclone 4100. Based on that the correct replacement kit is the part #K71-656-00 that you referenced as this is the exact replacement.

First thing you will need to do is check that all of the wiring of the actuator and your brake controller are correct. I attached a couple diagrams that should be helpful I spoke with my contact at Dexter and there is a way to troubleshoot your…

Torque specs for wheel lug nuts will vary depending on the diameter of the lugs, type of lug nut and the wheel's material. The linked chart details the recommended torque for many combinations. Dexter Hub/Drum #84546UC3 has 1/2-inch studs and…

You should be fine as most people do not have trailer wheels and tires balanced, but if you are having a shop mount the tires, and you want to have them balanced, it probably would not cost much more to have the setup balanced as well. One reason…