Customers compare T4813102 to these similar products
Products Featured in this Video
Today we're going to take a look at the Titan BrakeRite I Plug and Play Electric-Over-Hydraulic Actuator Kit. Now this electric-over-hydraulic brake actuator with mount on your trailer. It plugs in to the 7 way trailer connector and the electric current will run to this actuator when your tow vehicle brakes are applied. The signal triggers the pump and motor on the actuator and that will activate… see more >
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Videos
Help Articles
Expert Answers
I can indeed tell you the function and leads for each of the wire for the Dexter BrakeRite Electric Over Hydraulic Actuator for Disc Brakes #DX82KR. Here is what each is for, per the manual (which is also linked below): - White: 12V DC negative…
view full answer...Yes, the Titan BrakeRite does get plumbed into the hydraulic brake lines of the trailer it gets installed onto. Check out the picture I attached that shows this. I attached a copy of the instructions for you to check out also.
view full answer...The electric over hydraulic actuator we recommend the highest is the Hydrastar part #HBA16. This actuator is the favorite of our installers because of how well it works. It is the most reliable and has the quickest reaction time. It will be your…
view full answer...For the absolutely best performance and reliability you can't beat the HydraStar electric over hydraulic actuators. We have found that they are the most reliable, react the fastest and just in general work the best. For just the actuator…
view full answer...The HydraStar Marine Electric Over Hydraulic Actuator w/ Breakaway and 7-Way RV Harness #HS381-9067 is designed to work with an aftermarket electric over hydraulic brake controller. This kit will require you to wire in the components using the wire…
view full answer...Since both the 7k Roadmaster Comfort Ride system #RM-2460-2570 and the 8k version part #RM-2460-2580 are designed for 3 inch axles you can use either and in your case the 8k version would be perfectly compatible and give you a little more…
view full answer...You can lock out your surge brake actuator although it's not always the prettiest of solutions. You need to either weld the pieces together or drill holes through it putting in bolts to keep it from moving. It'll work but it…
view full answer...I'm guessing it is approximately 3-3/8" across if you measured it. Unfortunately there are no options that will slide in because it won't line up correctly, and everything is designed to fit a 3" tongue so it is too wide to mount an…
view full answer...The coupler I recommend for your boat trailer is the Demco Channel Tongue Trailer Coupler #12564, which fits a 3" wide channel tongue, has a 10,000 lb capacity and uses the eZ-Latch system to fit a 2" hitch ball. This will allow you to hook…
view full answer...I spoke with my contact over at Demco about coupler #12564. From the top (outside) of the coupler above the mounting holes down to the center of the mounting holes measures 1.029". What brand is the coupler you have now because the 1 inch…
view full answer...As shown in the provided photo, the approximate distance from the centerline of the trailer ball to the end of the coupler is 12 inches. The Demco #12564 accepts a 2 inch trailer ball.
view full answer...The only difference between the Demco Channel Tongue Trailer Coupler part #12564 and Demco Channel Tongue Trailer Coupler part #DM12717 is the bolt pattern which is just slightly different with one having an extra hole.
view full answer...