Review of Fastway Weight Distribution Hitch - e2 800 lbs TW WD With Sway Control - FA94-00-0800 Video

I attached a picture that shows where the #331-TPSI-007 installs in your 2017 Toyota Tacoma. It actually was designed to fit to the left of the steering wheel and not in the cubby area you mentioned. This would be the cleanest and easiest way to…

Yes, we do have weight distribution system shanks that have more drop than what you have now so that your trailer can sit level. For that you could use the part #C17123 which works with your e2 system and can do a drop of up to 8 inches.

I spoke with my contact at Curt regarding the Curt TruTrack Weight Distribution System #C17499 that you are installing on your trailer. He said that you can install the support brackets 6 to 6-1/2 inches from the end of the spring bar without…

When it comes to choosing between the Curt TruTrack Weight Distribution System w/ Sway Control #C17499 and the Equal-i-zer Weight Distribution System w/ 4-Point Sway Control #EQ37100ET you'll want to take a couple of things into consideration: 1.…

Weight distribution systems put a bit more torque on the hitch and frame of the vehicle due to the spring bars pulling up pretty hard on the head of the system. Not every vehicle/hitch is going to be heavy duty enough to allow this and not…

The best way to pick out a weight distribution system is to base it off of the loaded tongue weight of the setup when it is loaded and ready to tow. This figure also includes the weight of any cargo behind the rear axle of the tow vehicle. I attached…

Yes, they do. The Blue Ox Sway Pro item #BLU54TR and item #BXW2003 are a couple of our most popular weight distribution systems that include the 2-1/2" shank. If you already have a weight distribution system, or want to go with a different…

The Furrion kit part #FR67FJ and the #FR24FJ are the same except the #FR67FJ has LED mood lighting on it.

For a trailer that weighs 10,000 lbs when fully loaded, you'll need a higher-rated weight distribution hitch, and the best one for that is from Blue Ox, called the SwayPro. The correctly rated SwayPro that also fits a 2-1/2 inch hitch receiver is…

The easiest solution is going to be to use the adapter part #20142. This plugs into the 7-way on your Land Rover and has diodes installed in it already so that it can be used with a trailer that has LED taillights like what you have.

The snap up brackets included in the Reese Strait-Line Weight Distribution system will fit up to 2-1/4 inch wide channel frames. The height does not matter. As long as there is enough clearance up at the nose of the trailer frame, you should not have…

A 12V trailer power circuit will typically be wired with 12-gauge wire, part #12-1-1, but certainly there is no harm in using heavier 10-gauge wire #10-1-1. If one tow vehicle is longer than another, our installers may opt to use the heavier gauge…