Draw-Tite Ball Mounts - Fixed Ball Mount - 40202 Review Video

Yes, a weight distribution system like the Curt TruTrack Weight Distribution System part #C17499 will add stress to both the trailer and vehicle frame. That said, this stress is not usually enough to cause damage. The only exceptions to this would be…

Choosing the proper shank is a very important task. The shank will correspond to the height of both the vehicle and trailer. In order to choose the proper shank, you will need to do a bit of measuring. To select the correct rise/drop, you will first…

I would be happy to help! Since your tow vehicle is a 2021 Ram 1500 Crew Cab with the 5.7L Hemi I recommend going with an even stiffer weight distribution hitch than the Blue Ox TrackPro Weight Distribution w/ Sway Control - 7-Hole Shank - 13K GTW,…

I produced a short video and added dimensions to a photo for you so that you could measure and be sure the CURT Multi-Ball Adjustable Ball Mount, #D900, would work on your 2005 Jeep Liberty with rear mounted spare tire. The most critical measurements…

The Curt Slim Adjustable 2-Ball Channel Mount #C46KR that you referenced has two hitch pin holes that are one inch apart so the first pin hole has a distance of 10 inches from the ball center to the hitch pin and the other is 11 inches.

I went out to measure both Draw-Tite Trailer Hitches, #41904 and #41004. They will not use the same mounting locations. On #41904, the center to center distance between the two closest bolt holes is 4-3/4 inches. Between the center bolt hole and the…

The distance from the center of the hitch pin hole to the gusset welded onto the Curt #C45311 is 4 inches, as shown in the provided photo. If you're wanting something with a longer shank for additional clearance, I'd recommend the Curt…

Moving or relocating the factory OEM gas tank is not necessary to install the Reese Trailer Hitch, part #36025, on your 1989 Ford Pickup Truck. To complete your towing setup you may be interested in the following items: Draw-Tite Ball Mount, part…

I spoke with my contact at Brophy and she told me the measurement from the center of the pinhole to the nearest edge of the ball mount opposite the hitch ball hole is 2-1/2 inches. I have included a diagram that shows the requested dimensions.

Thanks for reaching out! From the hitch pin hole to the back end of the height adjusting bracket on the Curt Slim Adjustable 2-Ball Channel Mount - 2" Hitch #C46KR measures about 5-3/4" and then from that same hitch pin hole to the start of…

With hitch extenders the key thing to keep in mind is that when you use one you end up cutting the capacity of the hitch by 50 percent due to the increased leverage and movement created. So as long as the hitch of your Ram has twice the towing…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…