Curt Trailer Plug Covers - 4 Flat Cover - C58750 Review Video

I attached a chart that has all of the recommended lug nut torque specs for trailer wheels. Based on your studs being 1/2 inch, your wheels being 15 inches in diameter, and your lug nuts being coned you would want to torque your lug nuts to 90-120…

The best option we can offer you to secure the Sleeve-Lock Trailer Coupler part #CTA-196 is with a wraparound style trailer coupler lock, the Fastway Universal Trailer Coupler Lock part #FA86-0015-316 is what I recommend. I don't really have…

Curt recommends the use of 250 ft/lbs of torque when tightening the nuts of their hitch balls with a 1 inch diameter shank like the part #C40034 that you referenced. The general rule is for a 3/4" shank tighten to 150 ft/lbs For a…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

I can help explain the difference between the listing for towing weight and weight distribution towing capacity for you. Let's use the Draw-Tite Class V Trailer Hitch #DT45502, which is a confirmed fit for you 1992 Ford, that you were looking…

The Ford Transit if equipped with the factory tow package would have came with both a trailer hitch and trailer connector and they would both be located directly under the rear bumper so odds are you do not have either because they are not hard to…

The Putco Red Blade LED Tailgate Combination Light Bar part #P92010-60 which is the lightbar I recommend for your trailer has LED lights so the amp draw will be very minimal. The reason that this is important is because the total amp draw for each…

The existing wires on your boat trailer are for running lights and ground. The single wire replacement light should be connected to the brown wire and the white wire should be attached to the mounting screw since the unit must ground through the…

To upgrade to an EZ lube setup will require you to replace your axle or you could just replace the spindle. For a spindle with a 4 bolt mounting plate you would want the part #TRU74FR as it is an ez lube spindle. For a new hub/drum to fit this you…

There is no need to further re-pack the bearings with the Bearing Buddies like the Bearing Buddy Bearing Protectors - Model 2441 - Chrome Plated (Pair) #BB2441. So long as you maintain the grease levels, repacking the bearings isn't necessary,…

When you use the Bearing Buddy Bearing Protectors like #BB2441, so you do not need to take apart the wheel hub and repack the bearings. The Bearing Buddy Protectors have a spring loaded seal that keeps the moisture and debris out of the bearings.…

I wasn't able to obtain this information from the manufacturer so I went out to our warehouse and measured the Ark Locking Jerry Can Holder with Siphon Guard part #JCHF20D for you. The height of the mounting bracket is 10-3/4" which you can…