Review of CURT Trailer Hitch Ball Mount - Fixed Ball Mount - C33JR Video

For 2-1/2 inch hitches we have the hitch lock part #e98881 which is going to be a great option for you. It has a usable span of 3-5/8 inches which would easily fit your hitch and ball mount. This has a 5/8 inch diameter which is the correct size for…

Yes, it will. The etrailer Hitch Receiver Lock for 2" and 2-1/2" Hitches item #e98881 will work with both the BulletProof Hitches 2-Ball Mount item #MD206 and your hitch's 3-5/8" wide receiver. To get the etrailer lock keyed alike…

Any adapter you use to get your Blue Ox Ascent Tow Bar - Motorhome Mount - 2-1/2" Hitch - 7,500lbs Item #BX4375 into a 2" x 2" receiver will reduce the towing capacity by 50% which would make flat towing unsafe. You either need to…

We measured the distance from the center of the hitch pin hole to the center of the hitch ball and found that measurements was 10-1/2 inches for the Curt Ball Mount for 2-1/2" Hitches #C45460. This ball mount has a 20,000 lb capacity and gives…

The diameter of the hole on the platform of the #BWTS35100B is 1-1/4 inch so a 1-7/8 inch hitch ball like the part #C48810 would fit.

The Trailer Valet #TV64FR JXS 5K trailer jack is a pipe mount swivel jack that can be removed from the trailer by pulling the pin shown in the provided photo. If you click the provided link, you can see a video showing a typical installation.

In order for a Rack Tamer mud flap to fit on a ball mount there has to be at least 1 inch of clearance on the shank. The B and W Stow and Tow Ball Mounts like part #BWTS20040B would have no problem allowing the Rock Tamer to fit. I attached a picture…

It sounds like you're looking for the Clevis Adapter for B&W Tow & Stow 2" Ball Mounts - 10,000 lbs #BWTS35100B, which is compatible with the B&W Tow & Stow 2-Ball Mount - 2" Hitch - 5" Drop, 5-1/2" Rise - 10K…

My contact at Reese mentioned that the Reese Friction Sway Control Kit #83660 you were looking at can be installed on a trailer with an aluminum frame, but only if the trailer manufacturer is OK with the installation due to it requiring you to drill…

Yes, the B&W 2-1/2 inch to 2 inch adapter part #BWRHXA2182 that you referenced will fit the 2-1/2 inch hitch you have installed on your 2017 Ford F-250.

The B&W Hitch Receiver Reducer Sleeve #BWRHXA2182 that you referenced does not have a flange that goes around the end of the hitch tube like the factory sleeve adapter has. We don't have any options for hitch reducers that do have the flange…

For a 2 inch hitch ball that will work perfectly with the Curt Ball Mount #C45070 you mentioned I recommend the Tow Ready #63845. When installing the ball it should be torqued down to 250 foot pounds. I have attached a couple short video reviews on…