Review of CE Smith Boat Trailer Parts - Roller and Bunk Parts - CE27845 Video

The way the Ladder Roller for Rhino-Rack Heavy-Duty Crossbars #RR1500 works is that the top bracket mounts into the t-tracks of your bars and roller is on the side. That means they can't be flipped upwards since there are no t-tracks on the…

I spoke to my contact at Rhino Rack and he informed me that the length of the roller on the Rhino Rack Ladder Roller #RR1500 that you referenced is 56-1/4 inches. Check out the picture I attached to see this measurement.

CE Smith Post-Style Guide-Ons #CE27626 were designed to fit trailer frames that are up to but no larger than 3 inches wide and 4-1/4 inches tall. At 2 by 4 inches your frame does meet that description! I have linked a video review for you.

To choose a compatible hub assembly for any spindle the key is knowing the inner and outer bearing part numbers, or if they are not available, precise dimensions of the spindle at the points where the bearings and grease seal ride. These points on…

Yes, it is possible to switch from center rollers to bunk rollers on a boat trailer. For this, you will first need to remove the center rollers and then you can install a set of bunk rollers, part #CE27710 along with part #CE10000G-4 to support the…

The best option in my opinion is to use the Dutton-Lainson Boat Trailer Deluxe Roller Bunk - 5' Long Sections - 12 Sets of 3 Rollers #DL21741 which will allow you to angle the set farther up the trailer to help you center the hull but I recommend…

The B78-13 tires you mention convert to metric size 175/80-13. The 175/80-13 tires are available in three load ratings. B: 1100 lb at 35 psi C: 1360 lb at 50 psi D: 1610 lb at 65 psi You would choose the load rating based on the capacity of your…

You can use springs with a lower capacity than your existing springs to help provide an easier ride for your PWC. The #SP-178275 springs are a great choice. It is important to keep in mind that going with a lower weight rated spring will reduce the…

I've had to do this before, so I understand your concern about the carpet getting shredded. What I did was take a sharp utility knife and cut a small X right where I wanted to drill my holes. This worked very well and didn't rip up the…

It can be a flat end as long as the flat part is long enough that it can reach past the wet bolt just fine. For your application it looks like the 4-Leaf Slipper Spring w/ Radius End for 2,000-lb Trailer Axles #e69SR is the closest that we have as…

So the U-Bolt will secure the CE Smith Light Duty, Vertical Bunk Bracket #CE10603G with the ends pointing towards the back of the trailer. If you look at the picture you took it looks like those fasteners holding your current brackets could be…

The Crossbars for Malone MicroSport Trailers - 78" Long - Galvanized - Heavy Duty #MPG4001 are an updated version of the Crossbars for Malone MicroSport Trailers - 78" MPG495. They are 78" and can be used in place of MicroSport…