Review of CE Smith Boat Trailer Parts - Roller and Bunk Parts - CE26265G40 Video

Yes, if you'd like you can adjust the CE Smith Narrow V-Wing Bolster Bracket for Pontoon Boat Trailers #CE26265G40 along the frame.

With mounting the CE Smith Bolster Bracket #CE10100A40 on an angle crossmember rather than a square you will want to use some square tubing to act as a gusset so a U-Bolt #CE15501A will hold the bracket tight against the crossmember. This will ensure…

With trailer tires like #AM30670 you have to run the max tire pressure rating that's on the sidewall of the trailer. This ensures you get the full weight capacity of the tire and also that you prevent any heat build up which also leads to…

You always want to keep your trailer tires psi set to what is recommended. If the psi is higher or lower then the tire will not perform as the manufacturer states. For instance, the Kenda #AM30670 is rated for 990 lbs at 90 psi. If we were to deflate…

Tire size 4.80-12 is not found on vehicles, but is a common trailer tire size on smaller utility- and sport-type trailers. In trailer use you do want to inflate them to the maximum cold psi pressure noted on the tire sidewall. Trailer tires should…

The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-20 should be wired to the reverse light circuit on your 7-way. Although I do not have a specific wiring diagram, this is a simple process. There are two wires on your brake actuator. One will be the…

Wiring connections for the Electric Over Hydraulic Brake Actuator are as follows. Yellow - Cold side of breakaway switch, The wire that goes hot when a breakaway occurs. Black - Positive connection on breakaway switch, The wire that charges the…

The general rule of thumb is that you want your bunks to extend completely to the stern (rear) of the boat, or even and inch or two beyond. That way the transom has plenty of support as you drive down the road. The bunks can extend as far forward as…

If you look at the provided photo, you can see the bolt spacing of the CE Smith #CE10052-32G bolster bracket.

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

The distance from the base to the bottom of the "V" on the CE Smith V-Wing Bolster Bracket part #CE26244G is 2-1/4". I have attached a photo of this measurement for you as well.

I reached out to my contact at CE Smith, they are advising you to use one of the V-Wing bunk brackets #CE26244G on the back in the middle and one on the other end. Three brackets on each board.