Review of Bulldog Gooseneck Coupler - Adjustable Gooseneck Coupler - BD0287600300 Video

The outer diameter of the outer tube on the Bulldog Gooseneck Coupler part #BD0287600300 is 4-1/2" diameter.

I can absolutely understand not wanting to have to cut off the entire tube, but there just isn't an option for a tube with a coupler that goes over your 4" diameter tube. The reason for that is the inner tubing - the part with the…

I spoke with Access. The Toolbox Edition Soft, Roll-Up Tonneau Cover, part #A62439, is designed to fit behind toolboxes that between 19" and 21". With yours being only a half-inch longer than that, they stated that it would be a…

A gooseneck trailer, or in this case a converted 5th wheel trailer using Ranch Hitch, #AM3139, will still need safety chains as if required by law in the states you will be traveling. You will need to check with the Department of Transportation for…

As far as an inner tube only, the BX1 coupler #BD1289170300 is the only option. It sounds like you need one that is held in the outer tube with set screws such as #CG or #BD0287690300. Coupler #CG has a 4 inch diameter tube and #BD0287690300 has a…

You will most likely want to install a coupler with an outer and inner tube, like the Pro Series Gooseneck Coupler, item #PS0287790300 on your trailer. The installation of this type of coupler gives you the ability to tow the gooseneck trailer with…

I have two options that will allow for you to extend the connection point between your truck and trailer. The best option for you will depending on the gross trailer weight (GTW) and tongue weight (TW) of your trailer. As long as the GTW and TW of…

The recommended lug nut torque for your 7,000lb axle depends on a few factors like wheel size, stud size etc. Check out the attached photo which shows the torque specs for a variety of applications. I see you were looking at the Dexter Nev-R-Adjust…

The spindle dimensions you have do not match any of the standard trailer spindles that are available so we do not have any hubs that would fit them. Honestly your best option is going to be to replace the axles. Installing new spindles is a…

The thing about mobile home axles is that they are usually designed for one time use and the spindles have non-standard dimensions so we don't have hubs that would fit them. The best option I could make would be to replace the axles with new ones…

I recommend the etrailer Trailer Axle w/ Electric Brakes #e65SR for your tilt deck trailer. This axle will come preloaded with the brakes, hubs and has an easy grease spindle. It has your spring center of 74" with a hub face to hub face of…

Well shackle length is mainly based on the height difference between the front and rear hangers. The rear hanger normally doesn't hang as low as the front so that the shackle can offset the difference and add the ability to move. What is the…