2-1/2" Trailer Hitch Receiver Compatible With Curt 24" Hitch Extension On 2003 Ford F-250

Question

Question:

Can you help me price out a 2.5 receiver hitch and Curts 24" hitch extension kit?

asked by: Miguel

0

Expert Reply:

We do have the Curt Trailer Hitch Receiver # C15810 for your 2003 Ford F-250. This will give you a 2-1/2" receiver opening which will allow you to use the Curt Hitch Extension and Reducer # C45048 cut down to the 24" length you are needing.

Be sure to use the 24" Wiring Extension # TLW6024 so you will still be able to connect your trailer wiring.

expert reply by: Bud M

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

Hello Steve. I do have a good solution for you, but I cannot recommend using the Malone Adapter #MPG544. Since it is rated for towing only 4,000 lbs, your 8,000 lb towed vehicle would be double the max towing capacity. You are right about there being…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

For air springs there isn't a differentiation between Denali and and standard models on the 2021 GMC Sierra 1500. These kits do have fitment requirements based on whether or not you have 2WD or 4WD, an in-bed hitch, AT4 trim package, and adaptive…

view full answer...

Answer 5

Class I and Class II hitches both have a 1-1/4 inch receiver opening. The difference is that a Class I hitch has a lower tongue weight rating, usually 200 pounds and a lower towing rating, usually 2,000 pounds. A Class II hitch usually has a tongue…

view full answer...

Answer 6

The Curt High-Low Adapter #C59KR is designed for flat towing only. Curt doesn't even test it for accessories to give it a tongue weight rating. The Roadmaster #RM-048-4 is the most comparable with a distance of 9-5/8" from hitch pin to hitch…

view full answer...

Answer 7

I spoke with my technical contact at Curt and he informed me that the Curt Hitch #C15810 will fit spare tires with a wheel size of less than 20 inches. We happen to have a Ford F-350 on site, so we checked out the spare tire underneath and it was a…

view full answer...

Answer 8

I have a solution for you, and while most Fastway products are made in the U.S.A. it looks like the steel #FA49-00-5925 was not. Instead, I recommend using the aluminum Flash E Series HD Adjustable 2-Ball Mount #FA42-00-2925 which has a similar…

view full answer...

Answer 9

The drop of the Curt Class V #C15810, which is the distance from the top of the hitch crossbar to the underside of the vehicle frame where the hitch mounting flanges attach to the vehicle is 5.63 inches. The distance from the face of the receiver to…

view full answer...

Answer 10

A trailer hitch receiver can not be modified to increase the maximum tongue weight rating of the trailer hitch receiver. Modifying the receiver will void the manufacturer warranty and could cause a safety issue. For example the Curt Trailer Hitch…

view full answer...

Answer 11

Some newer cars, vans and small trucks, especially those with large, aftermarket tires, may require the use of Class S chains. Class S tire chains are designed for use on vehicles with restricted wheel well clearance. I have attached a photo that…

view full answer...

Answer 12

We have trailer hitches to fit both Ford E-250s and Ford F-250s however the hitches are different and not interchangeable. You didn't say which vehicle you need a hitch for. If you need one for an E-250 van then I recommend part #75703. Or if you…

view full answer...

2-1/2" Trailer Hitch Receiver Compatible With Curt 24" Hitch Extension On 2003 Ford F-250

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching