Recommended Weight Distribution System for a Underslung Coupler w/ a 1,500 lbs Tongue Weight

Question

Question:

Will this hitch work with a Jayco frame that has an underslung coupler?

asked by: Eric

0

Expert Reply:

I have a solution for you but the Curt TruTrack Weight Distribution System item # C17501 is not designed to be used with an underslung coupler.

Instead you will want the Blue Ox SwayPro Weight Distribution w/ Sway Control item # BXW1503. This system has the same capacity but is designed specifically to use on underslung coupler's like your Jayco trailer.

I have linked a review video below.

expert reply by: Jerred H

0

Answer 1

An underslung trailer coupler is one that attaches to the bottom of the trailer frame and an overslung one is one that attaches to the top of the frame. Measuring is not required if you just take a look at your coupler and see where it attaches to…

view full answer...

Answer 2

In regards to choosing a weight distribution system, it's better to be overrated than underrated. If you have a toy hauler trailer with varying loads, you'd want to make sure the system is capable of handing the heaviest load you carry. This…

view full answer...

Answer 3

To choose a weight distribution system you will need to go by the total tongue weight of the set up. This is calculated by taking the tongue weight of the trailer, when loaded and ready to tow, and adding to that the weight of anything loaded behind…

view full answer...

Answer 4

The Curt TruTrack Weight Distribution System is an excellent weight distribution system option with integrated sway control. It is one of my personal favorite systems being the best bang for your buck option. It comes with a pre-torqued 2-5/16"…

view full answer...

Answer 5

The only difference between Curt TruTrack weight distribution systems #C17501 and #C17500 is the capacity of the spring bars. Installation will be the same for both so you can use the video for C17500 as a guide to supplement the instructions that…

view full answer...

Answer 6

We do have what you need, as the only TruTrack that comes with the adjustment rods is the 15,000 lb/1,500 lb tongue weight Curt TruTrack Weight Distribution System with Sway Control #C17501. To get the adjustment rods for this system you will need…

view full answer...

Answer 7

Good question! Since the hole for the top bolt on the Curt TruTrack #C17501 that attaches the head unit to the shank is elongated you want to install either long or short adjustment rod in the top hole on the head unit.

view full answer...

Answer 8

With a tongue weight capacity ranging from 1000-1500 lbs, the Curt #C17501 TruTrack would be perfect for the Jayco travel trailer you described. The system provides proven weight distribution along with very effective trailer sway control, that will…

view full answer...

Answer 9

The difference between the two kits is the spring bar rating of the systems. The #C17500 has a spring bar that is slightly smaller in size to allow for it's lower rating than the #C17501 which is rated for 1,500 lbs tongue weight instead.

view full answer...

Answer 10

Weight distribution systems have tongue weight ranges that they are designed to work with. Ideally you want your setup's loaded tongue weight to fall right in the middle of the range. The part #C17501 that you referenced has a tongue weight range…

view full answer...

Answer 11

I think the issue you're running into is being caused by the underslung coupler which the Curt TruTrack Weight Distribution System part #C17501 isn't really designed for. It's possible you can still get the system setup and working but it…

view full answer...

Answer 12

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...