Should Adjustment Rod Be Installed on Top or Bottom Hole of Curt TruTrack Head Unit

Question

Question:

does the adjustment rod go in the top hole or bottom hole?

asked by: Donald J

0

Expert Reply:

Good question!

Since the hole for the top bolt on the Curt TruTrack # C17501 that attaches the head unit to the shank is elongated you want to install either long or short adjustment rod in the top hole on the head unit.

expert reply by: Jon G

0

click to enlarge

Answer 1

The castle nut of the Curt TruTrack part #C17501 does allow you to easily add or remove spring bar tension to compensate for a heavier or lighter tongue weight trailer. This does not necessarily increase sway control though. For more info on how to…

view full answer...

Answer 2

The Curt Weight Distribution Shank part #C17132 offers up to 9-1/4" of drop. In order to see if this is enough for your truck/trailer combo you will need to take some measurements. If the distance from the ground to the top inside edge of the…

view full answer...

Answer 3

Most manufacturer's say 10% under your truck's capacity but our recommendation is to go between 20%-25% below. So you would want to go no higher then 1,992 lbs - 1,867 lbs of tongue weight with your 2020 Chevrolet Silverado 2500. I have…

view full answer...

Answer 4

The picture you submitted shows a weight distribution head that has a 1,000 lb tongue weight and 10k total trailer weight when the spring bars aren't connected.

view full answer...

Answer 5

You can back up a trailer with a weight distribution system installed on as long as you don't end up in too tight of a turn. This is especially true with the Curt Weight Distribution System part #C17422 as it has a friction sway control system as…

view full answer...

Answer 6

To choose a weight distribution system you will need to go by the total tongue weight of the set up. This is calculated by taking the tongue weight of the trailer, when loaded and ready to tow, and adding to that the weight of anything loaded behind…

view full answer...

Answer 7

The Equil-i-zer Weight Distribution with 4-Point Sway Control, like #EQ37041ET, differs from the Fastway e2 Weight Distribution with 2-Point Sway Control #FA92-00-0450, because it does utilize 2 more points of steel-on-steel friction at the head of…

view full answer...

Answer 8

Weight distribution works to distribute the tongue weight of a trailer up to the front axle of the tow vehicle so that it will sit more level and handle/brake better. That being said the systems do not "reduce" tongue weight or allow you to…

view full answer...

Answer 9

I looked up the trailer connector wiring diagram for a 2007 Ford F-250 which should be the same as a Ford F-350 and found the 7-way trailer connector to contain the following wires: Orange = 12 Volt Power White = Ground Black/Green = Reverse Blue =…

view full answer...

Should Adjustment Rod Be Installed on Top or Bottom Hole of Curt TruTrack Head Unit

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching