Can Removable Receiver for EcoHitch 306-X7201 Be Locked to Vehicle

Question

Question:

what hitch lock works with the 306-X7201? On the install video, it shows the bolt as being threaded and the locks just seemed like a pin? 34061071-D?

asked by: BRYAN T

0

Expert Reply:

The Infinite Rule # 34061071-D lock can be used to secure a hitch mounted accessory into the removable receiver used by the # 306-X7201, but to secure the removable receiver to the hitch itself, the threaded bolt included with the hitch must be used. EcoHitch doesn't offer a locking pin for the removable receiver. EcoHitch recommends removing the receiver when it's not being used.

I've linked to the installation video you'd mentioned.

expert reply by: Mike L

0

Answer 1

I spoke with our installers and they told me that this will happen time to time. They said there are times when the auto manufacturer will have the holes moved just a bit, but they work with them to make it work. They told me that they use a tool…

view full answer...

Answer 2

The only trailer component that determines the speed rating of the trailer is the tires. All you have to do is simply replace your current tires with one that is rated for highway use, like the Kenda Loadstar #AM3S120 that you referenced, and you are…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 5

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 6

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

view full answer...

Answer 7

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 8

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 9

The best option we offer for your dump trailer is the Erickson Mesh Tarp and Truck Bed Cover part #EM57059 which measures 12' wide x 16' long. It's not the exact dimensions you wanted but it will still cover most of the area you need it…

view full answer...