Will the Draw-Tite QSP Trailer Hitch Silencer and Cover Work With Other Hitches

Question

Question:

Will part number 63080 fit a husky 2 inch hitch I have a 2018 Mazda CX-5 with a husky hitch

asked by: Scott C

0

Expert Reply:

The Draw-Tite QSP Trailer Hitch Silencer and Cover for 2" Hitch Receivers part # 63080 is specific to Draw-Tite Trailer Hitch Receivers. There isn't really a singular similar product with the same features, but you can use a cover like the etrailer Rubber Hitch Cover part # 22282 when not in use and the Gen-Y Anti-Rattle Clamp for 2" Hitch Receivers part # GY88XR when in use.

expert reply by: Conner L

0

Answer 1

Hitch accessories tend to wobble, especially those that use a 1-1/4 inch to 2 inch adapter. The threaded hitch pin can only do so much to combat the movement. The issue is that the shank of the accessory has to be slightly smaller than the opening…

view full answer...

Answer 2

An anti-rattle hitch pin will work for both hitch mounted accessories like bike racks and cargo carriers in addition to a ball mount with a hollow shank. However, most ball mounts have a solid shank and most anti rattle hitch pins used for bike racks…

view full answer...

Answer 3

The Gen-Y anti-rattle device you mentioned part #GY88XR does have a reputation as fitting really tightly. Some people report that using a hammer works for them, but I personally wouldn't want to mess with all of that. A U-bolt style anti-rattle…

view full answer...

Answer 4

The Gen-Y Anti-Rattle Clamp for 2" Hitch Receivers part #GY88XR works with any 2" trailer hitch receiver so you will not have an issue.

view full answer...

Answer 5

That is correct; the Draw-Tite QSP Trailer Hitch Silencer #63080 is only designed to fit on Draw-Tite brand aftermarket hitches. Instead, I recommend using the Gen-Y Anti-Rattle Clamp #GY88XR for your 2" hitch receiver to help eliminate rattling…

view full answer...

Answer 6

Hello Brian, we do offer some parts that will work for your application and will be very similar to the BPH1206EPR kit that you mentioned. Like you said, the 12 x 2-1/2 drums are pretty uncommon, so I would have to recommend going instead with the…

view full answer...

Answer 7

We have just what you're looking for with the Gen-Y Anti-Rattle Clamp for 2" Hitch Receivers #GY88XR. The sleeve acts as a wedge to take out play between your hitch receiver and extender. Although it does not not require a wrench and a…

view full answer...

Answer 8

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 9

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 10

Thanks for the Picture. What you have there is a 6 on 5-1/2" hub for a 3,500 lb axle. We do have a replacement hub for your Truryde RVD-H-65535 hub. The correct replacement will be part #AKHD-655-35-EZ-K. This will include the hub, bearings,…

view full answer...