Towing a 2017 Cadillac XT5 Behind Motorhome

Question

Question:

Can you tow with a tow dolly? The car has AWD, however, that can be disabled with a dash switch.

asked by: Richard K

0

Expert Reply:

Yes you can dolly tow your 2017 Cadillac XT5 if it's equipped properly. I looked up the owners manual and it says if it's equipped with the Driver Control Mode and it's in Tour Mode it can be dolly towed with a dolly like the Roadmaster Tow Dolly with Self-Steering Wheels and Electric Brakes #RM-2050-1 you referenced.

I linked the dolly, and included a couple of review videos for you to check out..

expert reply by: Robert C

0

Answer 1

Yes, we will have all the components you will need to be able to flat tow your 2022 Chevrolet Blazer. First you will need to select the correct baseplate. The Roadmaster Direct-Connect Base Plate Kit #RM28VR will only fit the 2.0L turbo engine…

view full answer...

Answer 2

I have a solution for you, but the Ford Edge, Explorer and Taurus vehicles equipped with the 2.0-liter EcoBoost I-4 or 2.3L EcoBoost I-4 engine CANNOT be towed four wheels down. The 3.5L EcoBoost Engines do allow for flat towing. For the FWD versions…

view full answer...

Answer 3

According to your owners manual, you can absolutely flat tow your specific model. It is not recommended to tow this vehicle over 65 mph. You will also need to start the engine and allow it to run for five minutes at the beginning of each day and…

view full answer...

Answer 4

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from the…

view full answer...

Answer 7

To get the B&W Patriot #BWRVK3200 to work with your 2006 Dodge Ram you're going to need a set of 5th wheel rails #DM8552016-71. These rails are custom fit to your vehicle so they'll just bolt right up to the frame. It is worth mentioning…

view full answer...

Answer 8

The Ram OEM 5th wheel puck system, shown in the linked photo and article, was launched in 2013 so what you have in your truck is likely to be an aftermarket installation of some kind. These newer Ram trucks with the factory prep can directly accept a…

view full answer...

Answer 9

Most fifth wheel rails are made to the same industry standard dimensions. They aren't all though. If you measure 22 inches on center between the two rails and they look like the rails of the #RP30035 that you referenced they would be the industry…

view full answer...

Answer 10

The head alone for the B&W Companion hitch #BWRVK3500 weighs about 70 pounds. Everything else weighs about 130 pounds. So the total weight of the hitch is approximately 200 pounds.

view full answer...

Answer 11

You do not have to use a sliding 5th wheel hitch in a short bed truck. In many cases, truck beds shorter than 8 ft do not have enough clearance between the trailer and truck to execute sharp turns. This is why sliding hitches were invented. Due to…

view full answer...