Pro Series Ring Swivel Jack Trailer Accommodation

Question

Question:

What size frame will this accomodate?

asked by: Bob G

0

Expert Reply:

Pro Series Round, Snap-Ring Swivel Trailer Jack will fit trailer frame members up to 4 tall and 3 wide.

expert reply by: Mike L

0

Answer 1

I went out to the warehouse and pulled the 2 jacks that would most likely fit and meet the needs of your application. First, I measured the Pro Series Round, Snap-Ring Swivel Jack, #PS1400300303, that you have referenced. This jack has a bolt hole…

view full answer...

Answer 2

The Pro Series Swivel Jack #PS1400300303 that you referenced should fit fine in your application. In the picture of the jack that I have provided has the measurements indicated. From the center of the mounting bracket to the foot plate is 11 inches.…

view full answer...

Answer 3

Sounds like you have a round tongue trailer that has a mounting bracket welded on it for a jack that match up with the mounting bracket of the part #PS1400300303 that you referenced. Normally we don't have a solution for round tube tongues aside…

view full answer...

Answer 4

The Pro Series Round Snap-Ring Jack, #PS1400300303, will bolt around your 2 inch trailer tongue. This jack can bolt to frames up to 3 inches wide by 4 inches tall and will have no problem fitting on your trailer. I have attached a photo showing the…

view full answer...

Answer 5

I went out o the warehouse to verify the measurements on the Pro Series Round, Snap-Ring Swivel Trailer Jack, #PS1400300303. It will fit either a 3 inch by 3 inch tall or a 3 inch by 4 inch tall trailer frame. I have made a picture showing the…

view full answer...

Answer 6

The shortest we have is about 13 inches from the bracket to the top of either the jack or the handle like the Pro Series Round, A-Frame Jack #PSRV20000103. Another option, since you may not get the clearance you want, is to switch to a side mount…

view full answer...

Answer 7

The Bulldog Topwind Jack part #BD151464 has 15 inches of travel and attaches to the trailer frame like the Pro Series you mentioned so it would be a perfect option. I attached an install video for more info as well.

view full answer...

Answer 8

The Bulldog Round Snap-Ring Swivel Jack #BD151464 referenced in your question is indeed a weld-on trailer jack. It is designed to mount onto the Weld-On Bracket #F500242 with the Snap Ring #BD500241. For a similar trailer jack that uses a bolt-on…

view full answer...

Answer 9

I went out to the warehouse to measure Bulldog trailer jack #BD151101. The overall length and width of the footplate is 7-1/2 x 4 inches. The part that gets welded to the trailer is L-Shaped. The lip that rests on top of the frame it 4-9/16 inches…

view full answer...

Answer 10

To verify fitment of the Bulldog Round, Snap-Ring Swivel Jack #BD151110 on your trailer you will need to measure the diameter of the Bracket #F500242 on your trailer. The diameter of the outer part of the bracket needs to be 2-1/2" for the…

view full answer...

Answer 11

There are jacks that will work for your 6" tall x 4" wide trailer frame, but they are going to need to be welded onto your trailer frame, something a professional welder should be able to do this in no time at all. The option I recommend is…

view full answer...

Answer 12

I have not heard of any complaints from customers about the Pro Series Trailer Jacks. The #PS1400800383 jack features a zinc plated inner tube and the jack is constructed of steel. The Pro Series #PS1400800383 is comparable to the Bulldog Square Jack…

view full answer...

Pro Series Ring Swivel Jack Trailer Accommodation

Product Page this Question was Asked From

Continue Researching