How To Add Air To the Trailer Valet XL Trailer Dolly

Question

Question:

How do you add air to the tires??? I cant find the valve.

asked by: Gerry

0

Expert Reply:

The Trailer Valet XL Trailer Dolly part # TVXL25 that you referenced uses a solid rubber tire, part # TVXLSR so there would be no inflation valve to add air. However, I think you might have the Trailer Valet 5X Swivel Jack and Trailer Mover part # STC-V211 which has pneumatic tires that you can add air to. The valve stem for these tires will be visible once you remove the wheel from the jack.

expert reply by: Conner L

0

click to enlarge

Answer 1

Yes, the Trailer Valet XL Trailer Dolly #TVXL25 does come with solid rubber tires. We carry the replacements here with part #TVXLSR if you ever need to replace one, but Trailer Valet did upgrade from the pneumatic tires for this superior design.

view full answer...

Answer 2

view full answer...

Answer 3

The tire part #TVTR that you referenced is a Load Range B tire in the size of 2.80/2.50-4 which means it does have a 250 lb per tire capacity. The Trailer Valet that this is used on is the #STC-V211 which has a 500 lb capacity total. The Trailer…

view full answer...

Answer 4

I reached out to Trailer Valet to get an answer for you, and they told me that the older Trailer Valet XL cannot swap out its pneumatic tires with the Replacement Solid Rubber Tire #TVXLSR. They went on to say that attempting to do this would remove…

view full answer...

Answer 5

The Trailer Valet XL Trailer Dolly with Chain Drive - 2-5/16" Hitch Ball #TVXL25 actually has a 10,000 lb trailer weight capacity and 1,000 lb tongue weight capacity. It is very likely that your 20 foot travel trailer will have a weight that is…

view full answer...

Answer 6

If your Trailer Valet Trailer Dolly came with the pneumatic tires you will unfortunately not be able to replace them with solid rubber tires #TVXLSR and attempting to do so would void the warranty on your dolly. If your tires are in need of…

view full answer...

Answer 7

If I had to guess the valve stem is bad and if you put pressure on it leaks. What you'd want to do is replace the inner tube with the part #TVIT.

view full answer...

Answer 8

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 9

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 10

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 11

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...