What Gauge Steel is RC Manufacturing T-Series Trailer Tongue Toolbox Made From

Question

Question:

What gauge is the steel?

asked by: RUSSELL D

0

Expert Reply:

The RC Manufacturing T-Series Trailer Tongue Toolbox # 350980 is constructed of 14 gauge steel.

I attached a review video link for this box for you to check out as well.

expert reply by: Jameson C

0

Answer 1

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 2

The Trimax Puck Lock for Trailer Door Hasps #TMX96RR cannot be keyed alike. While disappointing I'm sure, there is another option to consider, which is to order a quantity of two of the Trimax Puck Locks for Trailer Door Hasps #TMX73FR. The…

view full answer...

Answer 3

Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…

view full answer...

Answer 4

The only difference in the Demco Channel Tongue Trailer Couplers #DM16080-95 and #DM15931-95 is going to be the bolt pattern. One will have the 5-Bolt hole pattern and the other is going to have 4-Bolt holes. I have included images below showing…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Hi Ed, If I'm understanding you correctly your trailer's frame is 3" wide and the coupler needs to have a 2" ball. If so the Demco Channel Tongue Trailer Coupler #DM15000-52 you were looking at would be a compatible…

view full answer...

Answer 7

There really isn't a particular maximum trailer weight that is used to determine when brakes need to be added to both axles of a tandem axle setup. While I do still recommend checking your local laws, I am also not aware of any general laws…

view full answer...

Answer 8

Your surge coupler will have either a sticker or an engraving on it, typically near where the coupler is located. If you can get me that information and what you're needing to replace on it I'd be more than happy to help you find…

view full answer...

Answer 9

The difference is the trailer tongue size the coupler was designed to fit. The part #DX29FR is designed to fit a 3 inch by 4 inch straight tongue whereas the part #DX56FR is designed to fit a 3 inch by 5 inch straight tongue. Aside from that they…

view full answer...