Review of Dexter Brake Actuator - Replacement Inner Slide - DX99FR Video

Hey Erik, so if the coupler on your 2007 MasterCraft boat trailer is labeled a UFP or a Dexter actuator and looks like the #DX99FR then yes this inner member is correct replacement to get it working again. There isn't a way to look up what…

The proper replacement inner assembly member for your UFP 34043 would be indeed be the the Dexter #DX99FR which is compatible with disc brakes. The replacement has an electric lock out and has a 7500K capacity and is intended to work with a 2 inch…

The Dexter DX7.5L A-60 brake actuating coupler, part #DX89FR would be a direct replacement for the Dexter 34044 Disc Brake coupler you mentioned.

Thank you for the photos! To replace your Atwood 85738 actuator I recommend checking out the Demco 7K actuator which comes configured for Drum Brakes #DM72VR as well as Disc Brakes #DM62VR and a 2" hitch ball. This system is a bolt on…

The Replacement Inner Member #DX99FR will replace the current inner member on your UFP A-60 surge brake actuator. This is specific to tandem axle trailers that use disc brakes. It has the 2" ball coupler that you are needing as well.

The Dexter DX7.5L A-60 Brake Actuator part #DX89FR for disc or part #DX33FR for drum will work to replace the surge coupler of your Mastercraft boat trailer. I looked up your trailer and was not able to determine if it had disc or drum brakes which…

What you have is a UFP A-60 drum brake actuator Philip so to replace just the inner member what you would need is the part #DX97FR and you'd be set.

The main difference between The Dexter Inner Membrane #DX99FR and The Dexter inner Membrane #DX39FR is that the #DX99FR is for a tandem axle with disc brake setup. The #DX39FR is for a single axle with disc brake setup. Both Dexter membranes have a 2…

Reverse lock out solenoids are not polarity sensitive so you could run either the white or the blue wire of the Dexter coupler part #DX99FR as the power or ground and you'd be totally fine.

I took a look at the A-60 Surge Brake Actuator like the Dexter #DX56FR, and to remove the front pin you'll need to remove the locking ring from the front rolling pin on the passenger side, and push it out from the passenger side to the driver…

We do have a potential solution for you, but the Replacement Inner Member #DX99FR is not a suitable replacement for the TDE 8000LP. The #DX99FR is made only for Dexter DX7.5L and Legacy UFP actuators. The pins will not line up with a TDE I am sorry…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.