Review of Demco Straight Tongue Trailer Coupler - Standard Coupler - DM15629-52 Video

The outside diameter of the Wire - Jacketed 6-Wire - per Foot #DW04906-1 is 1/2" including the vinyl jacket.

The Demco Channel Tongue Trailer Coupler #DM15629-52 has a 7-3/4" channel from the back of the coupler to the inside lip near the ball latch.

The distance between the mounting holes is going to be the same between each one, or between each set. Center on center, they're going to be separated by 3 inches and the mounting holes are going to have a diameter of 1/2 inch. The channel…

The 60/40 axle placement formula is a great starting point and does take into account the tongue of the trailer from where the trailer sits on the hitch ball. Please keep in mind that this is a very basic formula or estimate for axle placement. For…

The 60/40 rule is a great guideline for setting up axle placement on a trailer. But in reality the goal is to place the axles where the trailer will have 10-15 percent of the total trailer weight as tongue weight. The distance you would need to…

Generally speaking you will want to have 3 inches from the top of your tire to the fender of your trailer to accommodate for suspension travel. Having a little more wouldn't hurt, but I wouldn't recommend any less than 3 inches.

Great question. As a general rule, when your trailer is loaded to it's full capacity, there should be a minimum clearance of 3 inches between the top of your tire and the underside of your fender.This should give you adequate clearance for…

I can understand that if your boat is loaded on the trailer, you don't want to remove one of the wheels to measure the fenders. Measuring a fender with the tire still mounted can be tricky, but it's not impossible. I've provided a diagram…

Since you need such a high weight capacity you'd need to use a coupler like the Buyers Products part #3370091560 which has the capacity you need of 10k, is for a 2 inch hitch ball. You will need to have spacers welded to the sides of the tongue…

I had the Demco Channel Tongue Trailer Coupler #DM12563 measured and have a diagram below. With its 10,000 pound capacity and eZ-Latch mechanism, this will definitely be a good option for you.

Yes, you can absolutely drill holes in your trailer tongue to install the 10,000 lb capacity Buyers Products Straight Tongue Trailer Coupler #3370091560. This is a pretty common occurrence due to the various bolt hole patterns of straight tongue…

The Phoenix Electric Trailer Jack with Remote #UF38-944055 has a multiple mount hole pattern. This pattern allows you to position the jack so the motor faces the front of the A-Frame, or it can be rotated so that the motor faces the drivers side of…